75.5754.07 LZR-MICROSCAN T Mounting Template 20230830
microscan
1”
1”
KEY
SPACER MOUNTING HOLES = 1/8”
SENSOR MOUNTING HOLES = 1/8”
OPTIONAL SENSOR MOUNTING HOLES = no more than 1/8”
SENSOR WIRE PASSAGE HOLE = 5/16”
• not to be used with Y-harness
• no more than 1” in diameter (UL10 compliance)
• ensure the wire passage hole is offset a minimum of 1 inch from
the hole on the other side of the door (UL10 compliance)
LEFT MOUNT
Always verify that the sensor does not interfere with the door frame.
Things to observe: distance from pivot edge, distance from top of door, frame
clearance, finger guard, door arm, etc.
Print settings must be set to “ACTUAL SIZE.”
Verify dimensions after printing.
Observe the level line on the sensor label
75.5754.07 LZR-MICROSCAN T Mounting Template 20230830
1”
1”
microscan
KEY
SPACER MOUNTING HOLES = 1/8”
SENSOR MOUNTING HOLES = 1/8”
OPTIONAL SENSOR MOUNTING HOLES = no more than 1/8”
SENSOR WIRE PASSAGE HOLE = 5/16”
• not to be used with Y-harness
• no more than 1” in diameter (UL10 compliance)
• ensure the wire passage hole is offset a minimum of 1 inch from
the hole on the other side of the door (UL10 compliance)
RIGHT MOUNT
Always verify that the sensor does not interfere with the door frame.
Things to observe: distance from pivot edge, distance from top of door, frame
clearance, finger guard, door arm, etc.
Print settings must be set to “ACTUAL SIZE.”
Verify dimensions after printing.
Observe the level line on the sensor label
-
1
-
2
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
BEA Americas LZR-MICROSCAN T User guide
-
Pleasant Hearth HWS-224172MH User guide
-
Nortec UL10 Operating instructions
-
XtremeAir Ultra UL10-U30 User manual
-
M3 Mobile UL10 User manual
-
Pleasant Hearth HWS-224172MH-B User manual
-
Omron Visionscape GigE Camera User manual
-
-
-
Honda E4500 Owner's manual
