2. Anova
  3. BRP300E

Anova BRP300E Assembly Instruction

  • Hello, I've reviewed the assembly instructions for the ANOVA Ultra Ultra Single-Side BRP300E bike rack. This document details the components, necessary tools, and step-by-step instructions for assembling your new 14-bike capacity rack. I understand the rack's modular design and the use of stainless steel hardware. Feel free to ask me any questions you might have about the assembly process or the rack's features.
  • What tools are needed for assembly?
    What type of hardware is included?
    What should I do before assembling the nuts to the bolts?
anovafurnishings.com
888.535.5005 tel
TOOLS NEEDED:
• Ratchet with 9/16" Socket
• 9/16" Wrench
Assembly Instructions
Ultra Ultra Single-Side Bike Rack,14-Bike Capacity
BRP300E - Powder Coated Finish
COMPONENT PARTS:
ASSEMBLY HARDWARE: All hardware is stainless steel.
(2) End Sections
(24 )
3/8" x 1.5"
Hex Head Bolt
(24 )
3/8"
Flanged Nut
(48 )
3/8"
Flat Washer
(2) Center Sections(1) Center Connector (2) Supports
ASSEMBLY:
Inspect the shipping container contents for damage and to
determine that all components and hardware are present.
1.
2. Lay all parts on a so work surface or on the shipping
packaging to prevent damage to nish.
NOTE: Before assembling the nuts to the bolts, it is
recommended that a light oil or petroleum jelly be applied
to the screw threads.
1
151.13
34.00
74.37 74.38
148.75
.50
MOUNTING HOLE LOCATIONS
151.13
34.00
74.37 74.38
148.75
.50
MOUNTING HOLE LOCATIONS
151.13
34.00
74.37 74.38
148.75
.50
MOUNTING HOLE LOCATIONS
1
Ultra Bike Racks
Manufactured in the U.S. 2
Note: Please contact Customer Care at 1-866-797-1761 when ordering replacement parts.
4/19/2022 Copyright 2022 ANOVA®
3. One at a time, align Center Section holes above End Section
and Center Connector holes as shown.
Using 4 bolts, 4 nuts and 8 washers, secure the Center
Section to the End Section as shown.
Repeat to secure the other side of the Center Section to
the Center Connector. Tighten all hardware nger tight so
adjustments can be made during assembly.
Using 2 bolts, 2 nuts and 4 washers, secure the Support to
the End Section as shown.
Repeat to secure the other side of the Support to the
Center Connector. Tighten all hardware nger tight so
adjustments can be made during assembly.
Aer everything is in place, tighten all hardware with the
ratchet and 9/16" wrench. Re-tighten all hardware aer
two weeks.
4. Align both Supports' holes above End Section holes as
shown.
5. Repeat steps 3-4 with the other Center Section, End
Section and Support.
Parts Assembled Parts
3.
4.
/