Anova BRP300FA Assembly Instruction

  • Hello! I've reviewed the assembly instructions for the ANOVA BRP300FA Ultra Single-Side Bike Rack with Fusion Advantage Finish. This document provides a step-by-step guide for assembling the 7 bike capacity rack, including the necessary tools and hardware. I am ready to help you with any questions you might have regarding the assembly process or the specifications outlined.
  • What tools are required for assembly?
    What type of hardware is included?
    How many bikes can this rack hold?
Contact Us:
800.231.1327
TOOLS NEEDED:
Ratchet with 9/16" Socket
9/16" Wrench
Assembly Instructions
BRP300FA - Ultra Single-Side Bike Rack, Fusion Advantage Finish,
7-Bike Capacity
COMPONENT PARTS:
ASSEMBLY HARDWARE: All hardware is stainless steel.
(2) End Sections
(12 )
3/8" x 1.5"
Hex Head Bolt
(12 )
3/8"
Flanged Nut
(24)
3/8"
Flat Washer
(1) Center Section (1) Support
ASSEMBLY:
Inspect the shipping container contents for damage and to
determine that all components and hardware are present.
1.
2. Lay all parts on a soft work surface or on the shipping
packaging to prevent damage to nish.
NOTE: Before assembling the nuts to the bolts, it is
recommended that a light oil or petroleum jelly be applied
to the screw threads.
1
151.13
34.00
74.37 74.38
148.75
.50
MOUNTING HOLE LOCATIONS
151.13
34.00
74.37 74.38
148.75
.50
MOUNTING HOLE LOCATIONS
1
Ultra Bike Racks
2
Manufactured in the U.S.
Note: Please contact Customer Care at 1-866-797-1761 when ordering replacement parts.
Copyright 2022 Anova®11/08/2022
3. One at a time, align Center Section holes above End Section
holes as shown.
Using 4 bolts, 4 nuts and 8 washers, secure the Center
Section to the End Section as shown.
Repeat to secure the other side of the Center Section to
the other End Section. Tighten all hardware nger tight so
adjustments can be made during assembly.
Using 2 bolts, 2 nuts and 4 washers, secure the Support to
the End Section as shown.
Repeat to secure the other side of the Support to the
other End Section. Tighten all hardware nger tight so
adjustments can be made during assembly.
4. Align both Supports' holes above End Section holes as
shown.
5. After everything is in place, tighten all hardware with the
ratchet and 9/16" wrench. Re-tighten all hardware after
two weeks.
Parts Assembled Parts
3.
4.
/