2. Progress Lighting
  3. PECUE-UR-30

Progress Lighting PECUE-UR-30, PECUE-UR-30-RC Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Progress Lighting PECUE-UR-30 Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Assembly & Installaon Instrucons
LED Combo Exit Sign
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precauons should always be followed including the following
.
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
1. Do not let power supply cords touch hot surfaces.
2. Do not mount near gas or electric heaters.
3. Equipment should be mounted in locaons and at heights where it will not readily be subject to tampering by unauthorized
personnel.
4. The use of accessory equipment not authorized by the manufacturer may cause an unsafe condion.
5. Do not use the equipment for other than its intended purpose.
6. Servicing of this equipment should be performed by qualified service personnel.
7. Do
not use outdoors
8 . Max Mounng Height:9
INSTALLER:
• SEE UNIT LABEL FOR ADDITIONAL MODEL SPECIFICATIONS
• SAVE THESE INSTRUCTIONS FOR USE BY OWNER/OCCUPANT
WARNING – This product contains chemicals known to the state of California to cause cancer, birth defects and/or other
reproducve harm. Thoroughly wash hands aer installing, handling, cleaning, or otherwise touching this product.
Ceiling Mounng
1. Connect 20” jumper leads to A/C input leads in J-Box, fasten J-Box bracket to J-Box. Use BLACK wire for 120V, or RED wire
for 277V, WHITE wire is common.
2. Fasten canopy to J-Box
3. Snap housing to canopy
4. Connect and trim input leads to socket leads at upper l
e corner of housing wire channel.
5. Secure faceplate to housing and remover the proper arrow as required.
Back Mounng
1. Connect 20” jumper leads to A/C input leads in J-Box, fasten J-Box bracket to J-Box. Use BLACK wire for 120V, or RED wire
for 277V, WHITE wire is common.
2. Remove necessary knockouts and fasten back cover to J-Box.
3. Snap housing to back cover.
4. Connect and trim input leads to socket leads at upper le corner of housing wire channel.
5. Secure face plate to housing.
93066294_A Page 1 of 1
WARNING:
Unused wires must be capped usi ng enclosed wire nuts.
Wiring diagram
BLA C K 1 20VAC
LED BOARD
RED 2 7 7 VAC
WHI T E C OM
T R S
RE
D
BL
A
CK
REMOTE
BAT.
3. 6V
18 00mA H
R
ED
BLA C
K
RE
D
B
LA
C
K
DE
R
)+(
KCALB )-(
RE
D
RED
B
L
ACK
BLA C K 1 2 0VAC
LED BOARD
RED 2 7 7 VAC
WHI T E C OM
T R S
R
ED
B
L
A
C
K
BAT.
3. 6V
R
ED
B
L
A
C
K
DER )+(
KCALB
)
-(
R
ED
RED
B
L
ACK
900mAH
Warning: Unused wires must be capped using enclosed wire nuts
Wiring Diagrams
/