Page is loading ...
(Not Included)
E-commerce Division - Enitial Lab
Page 1 of 20
18-10-05
FGI-18710C24
Page 2 of 20
Page 3 of 20
Page 4 of 20
Page 5 of 20
Page 6 of 20
BUFFET
MODEL #FGI-18710C24
Get Ready
Please group boards as below
Page 7 of 20
Page 08 of 20
Apply a small dab of glue into dowel holes
of panels before inserting dowels (#3).
Refer to page 5 on how to secure cam
locks (#2) onto cam bolts (#1).
Page 09 of 20
Page 10 of 20
Page 11 of 20
Cover the cam locks (#2) on this step
with stickers (#12).
Always align panels first before securing.
Page 12 of 20
This finished side of panel (#H) is facing up.
Page 13 of 20
Finished side of panel (#H) is facing up.
Page 14 of 20
Page 15 of 20
Slide back panels (#M,N) through the thin lined gaps of the unit.
Page 16 of 20
Page 17 of 20
Extend drawer rails full, then align drawer hole to the
smallest hole of the drawer rails. Secure by using
bolts (#7).
Page 18 of 20
This screw adjusts depth.
This screw adjusts length.
Page 19 of 20
Insert fixative plates (#8) all around the grooves of the back
panels (#M), then secure by using screws (#8).
Page 20 of 20
/
