2. luminii
  3. Place

luminii Place Installation guide

  • Hello! I've reviewed the Installation Sheet for the SENSO round flushmount LED display. This document provides essential instructions for installation, emphasizing the correct wiring procedures, proper location and the use of a constant current driver. It also mentions that a licensed electrician should perform the installation and a limited two year warranty is offered. I'm ready to answer your questions about the device.
  • Where is this product suitable for?
    What type of loads should this product not be on the same circuit with?
    Who should install this product?
read and follow these instructions before
installing or maintaining this product
location
• this product is suitable for
DRY INDOOR LOCATIONS ONLY
• make sure this product is NOT on the same circuit as
inductive loads, (e.g. fluorescent bulbs, discharge bulbs,
ventilation fans, etc...)
safety
• Do not switch on line voltage until all wiring has been
complete
• Incorrect wiring will result in irreparable damage to the
LED and power supply
• This product should only be installed by a licensed
electrician
• DO NOT CONNECT DIRECTLY TO LINE VOLTAGE
INSTALLATION
SHEET
PLACE round
flushmount display LED
IMPORTANT INSTRUCTIONS
INSTALLATION
A
B
C
switch off the line voltage supply
Cut a hole according to dimension
Connect the LED to driver, driver to line voltage
according to the drawing
Put the fixture in place
• This product must be installed in accordance with all
applicable installation codes and ordinance
• Limited two (2) years warranty
• Warranty is void in the eventuality of unauthorized
modifications and/or improper use
WARRANTY
43mm
CUTOUT C
40mm
52mm
A
LEDLEDLED
constant
current
driver AC
class II wiring
driver: constant current driver, 350mA
B
C
25mm
rev. 2014 01
Page 1 / 1 www.sensolighting.co
m
302 50 Ave SE Calgary Alberta T2G 2A9 Canada • E: info@sensolighting.com • T: 403.216.7043 • F:403.216.7045
/