2. luminii
  3. Set

luminii Set Installation guide

  • Hello! I've reviewed the Installation Sheet for the SET recessed display LED. This document provides important details about installation, including the cutout dimensions, wiring instructions, and safety precautions. I'm ready to answer any questions you have about this product and its installation.
  • What type of locations is the product suitable for?
    What should I avoid on the same circuit as this product?
    What could happen if wiring is done incorrectly?
    Who should install this product?
    What is the warranty period for this product?
36mm
CUTOUT
read and follow these instructions before
installing or maintaining this product
location
• this product is suitable for
DRY INDOOR LOCATIONS ONLY
• make sure this product is NOT on the same circuit as
inductive loads, (e.g. fluorescent bulbs, discharge bulbs,
ventilation fans, etc...)
safety
• Do not switch on line voltage until all wiring has been
complete
• Incorrect wiring will result in irreparable damage to the
LED and power supply
• This product should only be installed by a licensed
electrician
• DO NOT CONNECT DIRECTLY TO LINE VOLTAGE
INSTALLATION
SHEET
SET
recessed display LED
IMPORTANT INSTRUCTIONS
INSTALLATION
A
B
C
switch off the line voltage supply
Cut a hole according to dimension
Connect the LED to driver, driver to line voltage
according to the drawing
Put the fixture in place, allowing the spring clips
to release
• This product must be installed in accordance with all
applicable installation codes and ordinance
• Limited two (2) years warranty
• Warranty is void in the eventuality of unauthorized
modifications and/or improper use
WARRANTY
LEDLEDLED
constant
current
driver AC
class II wiring
driver: constant current driver, 350mA
B
C
A
C29mm
31,5mm
42mm
rev. 2015 01
Page 1 / 1 www.sensolighting.co
m
302 50 Ave SE Calgary Alberta T2G 2A9 Canada • E: info@sensolighting.com • T: 403.216.7043 • F:403.216.7045
/