Chevrolet Fuel Pressure Regulator Valve 2 Operating instructions

Type
Operating instructions
2022-06-23, 6:18 PMDocument ID: 2411038
Page 1 of 2https://gsitlc.ext.gm.com/gsi/showDoc.do?pubName=Cheyenne,%20Si…ffectiveDate=Jun%201,%202022&laborOpCode=&windowID=si999061230
2013 Chevrolet Silverado - 4WD | Cheyenne, Sierra, Silverado VIN C/K Service Manual 3087 | Engine |
Engine Controls/Fuel - 6.6L LGH or LML | Repair Instructions | Document ID: 2411038
Fuel Pressure Relief Valve Replacement (Fuel Pressure
Regulator Valve 2)
Fuel Pressure Relief Valve Replacement
Callout Component Name
Preliminary Procedure
Remove the front exhaust gas recirculation cooler. Refer to Exhaust Gas Recirculation Valve Cooler
Replacement.
Fuel Pressure Relief Valve
Warning: Verify that there are no fuel leaks in the fuel system. Failure to identify any
leaks could result in no start, stall, vehicle damage or bodily injury.
Caution: Refer to Component Fastener Tightening Caution.
Procedure
1. Screw in the adaptor while holding the valve body.
2. Disconnect the electrical connector.
2022-06-23, 6:18 PMDocument ID: 2411038
Page 2 of 2https://gsitlc.ext.gm.com/gsi/showDoc.do?pubName=Cheyenne,%20Si…ffectiveDate=Jun%201,%202022&laborOpCode=&windowID=si999061230
1
3. If the scan tool DPF Soot Mass is less than 30grams, enable the DPF. Refer to
Diesel Particulate Filter (DPF) Regeneration Enable.
4. If the scan tool DPF Soot Mass is 30grams or greater, refer to Diesel Particulate
Filter (DPF) Service Regeneration.
5. While holding the outer hex nut 90 degrees to the torque wrench, tighten the inner
hex nut using the following specifications.
6. Check the fuel system for leaks.
Tighten:
First Pass 60Y (44lbft)
Second Pass Loosen 90 degrees
Third pass 85Y (63lbft)
© 2022 General Motors. All rights reserved.
  • Page 1 1
  • Page 2 2

Chevrolet Fuel Pressure Regulator Valve 2 Operating instructions

Type
Operating instructions

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI