Danger: The noise cancelling foam component MUST be replaced if it has been exposed to
engine fluids. Failure to replace the noise cancelling foam component that has been
exposed to engine fluids may result in an engine fire resulting in catastrophic engine
damage, and possible injury or death.
4. Wrap a shop towel around the fuel injection fuel rail fuel pressure sensor (1) at the fuel injection
fuel rail to absorb any fuel that may leak out.
5. Remove and DISCARD the fuel injection fuel rail fuel pressure sensor (1).
Installation Procedure
Caution: Refer to Component Fastener Tightening Caution.
1. Install the NEW fuel injection fuel rail fuel pressure sensor (1) and tighten to:
1.1. First Pass: 20 YY (15 lb ft)
1.2. Final Pass: 15 degrees