2. Chevrolet
  3. J95
J95

Chevrolet J95 Operating instructions

  • Hello! I have reviewed the provided service manual for the Silverado J95, J96 Trailer Brake Control Module Replacement. The document includes step-by-step instructions for removal and installation, including details like disconnecting electrical connectors and tightening fasteners to specific torque. I am ready to answer any questions you have regarding this procedure.
  • What is the first step in the removal procedure?
    What should be done with the spare tire before starting?
    What torque should be applied to the trailer brake power control module nuts?
2022-04-10, 9:52 AMDocument ID: 3618432
Page 1 of 4https://gsitlc.ext.gm.com/gsi/showDoc.do?pubName=Cheyenne,%20Si…EffectiveDate=Apr%201,%202022&laborOpCode=&windowID=si172821036
2015 Chevrolet Silverado - 4WD | Cheyenne, Sierra, Silverado Service Manual 7526957 | Document ID: 3618432
Trailer Brake Control Module Replacement (J95, J96)
Removal Procedure
 1. Place the ignition switch in the OFF position.
 2. Lower and secure the spare tire and wheel assembly.
 3. Disconnect the chassis control module and the trailer brake power control module electrical
connectors.
 4. Loosen, but do not remove, the chassis control and trailer brake power control module bracket
bolts (1).
 5. Slide the chassis control and trailer brake power control module bracket toward the right of the
vehicle and remove the assembly from the vehicle.
2022-04-10, 9:52 AMDocument ID: 3618432
Page 2 of 4https://gsitlc.ext.gm.com/gsi/showDoc.do?pubName=Cheyenne,%20Si…ffectiveDate=Apr%201,%202022&laborOpCode=&windowID=si172821036
 6. Remove the trailer brake power control module nuts (1).
 7. Remove the trailer brake power control module (1) from the bracket.
Installation Procedure
© 2022 General Motors. All rights reserved.
2022-04-10, 9:52 AMDocument ID: 3618432
Page 3 of 4https://gsitlc.ext.gm.com/gsi/showDoc.do?pubName=Cheyenne,%20Si…ffectiveDate=Apr%201,%202022&laborOpCode=&windowID=si172821036
 1. Install the trailer brake power control module (1) to the bracket.
Caution: Refer to Fastener Caution.
 2. Install the trailer brake power control module nuts (1) and tighten to 9 YY (80 lb in).
2022-04-10, 9:52 AMDocument ID: 3618432
Page 4 of 4https://gsitlc.ext.gm.com/gsi/showDoc.do?pubName=Cheyenne,%20Si…ffectiveDate=Apr%201,%202022&laborOpCode=&windowID=si172821036
 3. Install the chassis control and trailer brake power control module bracket assembly to the frame.
 4. Slide the chassis control and trailer brake power control module bracket assembly fully into the
slotted holes of the vehicle frame.
 5. Tighten the chassis control and trailer brake power control module bracket bolts (1) to 9 YY (80 
lb in).
 6. Connect the chassis control and trailer brake power control module electrical connectors.
 7. Raise and secure the spare tire and wheel assembly.
 8. If installing a new trailer brake power control module, program the module. Refer to Trailer Brake
Power Module Programming and Setup.
/