ESi Ergo 2ESP-C60-ADJ-SLV User guide

  • I have reviewed the user manual for the ESI Ergonomic Solutions Work Surface positioning. It provides visual instructions for correctly orienting and aligning both 24" and 30" rectangle work surfaces with the table base. I am ready to assist with any questions you may have about the positioning process.
  • How should the work surface be placed initially?
    Where should the cross channels of the table base be placed?
    How should the table base be positioned on the work surface edges?
    Where should the back of the 24" work surface be aligned?
    How to verify the base is centered?
    How should back of a 30" work surface be aligned?
24” Rectangle Work Surface
WORK SURFACE POSITIONING
Visual Aid
1. The work surface
should be placed on
the ground with the top
side of the surface
facing down and the
bottom side of the work
surface facing up.
Top
2. Place the height adjustable table base on top
of the work surface. The cross channels should be
on top of the work surface while the feet will be
protruding upwards.
3. On the right and left side of the work surface,
position the table base as close to the edge as it will
allow.
1” overhang
recommended
Adjustable Table:
Adjustable Table:
4. For a 24” work surface, the back of the work
surface should be aligned with the back of the
feet for maximum support.
5. When the base is centered, verify that the feet do
not stick out past the edge of the work surface on
the front or the back. Adjust accordingly.
5.
24” Rectangle Work
Surface
4.
6. For a 30” work surface, the back of the work
surface should be aligned with the back of the
feet for maximum support.
30” Rectangle Work Surface
6.
ESI Ergonomic Solutions ©
Need Help? Please Contact Us.
Phone: 1-800-833-3746
Email: customerservice@esiergo.com
Web: www.esiergo.com
The work surface is now ready to be attached to the base.
/