1. Schematic diagram
2. Component list
1, 2, 3 and 4 are power cable joints
3. Installation steps
Please install according to the figures and steps below:
A. Installation positioning
It is suggested to hang the lamp 71in above the floor
to get the best view angle;
B. Fix the hook: Drill a hole on the ceiling above the
lamp to install expansion tube + hook (4);
C. Install hold-nut: Spin and fasten the hold-nut (2) on
the top of the lamp (1). Note: The hanging chain (3)
is already tied together with the hold-nut; please
make sure to fasten the hold-nut in case it gets loose
and falls.
D. Connect power wire to the lamp: Insert the plug (2)
of the power wire (6) to the jack (1) on the top of the
lamp (1);
E. Hang lamp and arrange power wire: Hang the
hanging chain (3) and power wire (5) that have
already been fixed on the lamp (1) to the hook (4). You
can adjust the length of the chain according to the
distance between the lamp and the ceiling;
F. Power on: Connect the joint (3) of the power wire (5)
with the joint (4) of the adapter (6) and then connect
the adapter with the main power source.
G. Examination: When setting the switch on the bottom
of the lamp (1) (see the small figure under) to the left
side to start it, the lights in the lamp shall be lighted,
snowflake shall fall down and music should start at the
same time. If it fails to perform such functions, it is
necessary to check if the joints 1, 2, 3 and 4 are well
connected. You can also turn the switch to the right
side to close the music.
H. Adjust direction: You can adjust the direction of the
lamp by spinning the direction of the hook (4) to your
satisfaction.
Caution
The product is fragile, do not exert too
much strength or drop it during the
assembly and use. Item should be
securely hung on the ceiling.
The product is not water proof, do not use
it outdoors.