Brodit 854872 Datasheet

Category
Holders
Type
Datasheet

This manual is also suitable for

28 January, 2015, www.brodit.com, © 2015 Brodit AB
Product 854873
854873 ProClip
Angled mount, ONLY for models with a High Center Information Screen
The ProClip is a mounting bracket for the vehicle’s dashboard. Onto the ProClip you can install e.g. a holder for
your mobile phone or PDA or a handsfree set etc. Safe and convenient -always within easy reach. The ProClip is
car specific and easy to install. The installation is quick, no special tools or dismantle of the dashboard is required
and it will not damage the interior of the vehicle. Made in black ABS plastic. Comes with detailed instructions.
EAN: 7320288548739
Item no 854873 fits:
Ford Excursion 11-15 (For USA)
Ford F-Series 250 11-15 (For USA)
Ford F-Series 350/450 11-15 (For USA)
Ford F-Series 550/650/750 11-15 (For USA)
Ford Super Duty 11-15 (For USA)
1(2)
1. 2.
INSTALLATION INSTRUCTIONS
4.3.
Please read all of the instructions and look at the pictures before attaching the ProClip.
1. Open the door on top of the dashboard. Use the enclosed alcohol pad to clean the area where the ProClip is to
be installed. Peel of the adhesive tape cover on the ProClip. Place the lower angled edge of the ProClip under
the padded part of the dash top.
2. Press the upper part of the ProClip forward until the J-shaped angled edge on the top hooks over the dash
edge where the dash door is open.
3. Make certaom the ProClip goes into the seam between the dash top and the inside tray of the box. The door
on top of the dash should close easily.
4. The ProClip is in place.
2(2)
  • Page 1 1
  • Page 2 2

Brodit 854872 Datasheet

Category
Holders
Type
Datasheet
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI