Brodit 854967 Datasheet

Category
Holders
Type
Datasheet
29 January, 2015, www.brodit.com, © 2015 Brodit AB
Product 854967
854967 ProClip
Angled mount
The ProClip is a mounting bracket for the vehicle’s dashboard. Onto the ProClip you can install e.g. a holder for
your mobile phone or PDA or a handsfree set etc. Safe and convenient -always within easy reach. The ProClip is
car specific and easy to install. The installation is quick, no special tools or dismantle of the dashboard is required
and it will not damage the interior of the vehicle. Made in black ABS plastic. Comes with detailed instructions.
EAN: 7320288549675
Item no 854967 fits:
Kia Candenza 14-15 (For USA)
1(2)
1. 2.
INSTALLATION INSTRUCTIONS
4.3.
Please read the instructions and look at the pictures before attaching the ProClip.
1. Use the enclosed alcohol pad to clean the area where the ProClip is to be installed. Peel off the adhesive tape
cover on the ProClip. Press/hook the edge on the lower part of the ProClip into the seam under the panel
surrounding the radio. Note: you may have to slide the mount a little to the left/right for it to fit into the seam.
2. Push upward on the lower angled edge of the ProClip to further insert the edge into the seam while rotating the
ProClip upward. Using your forefingers, flex the upper angled edge into the seam between the stereo and the
surrounding panel frame. Press firmly forward on the upper part of the ProClip so the angled edge goes all the
way into the gap between the stereo and the surrounding panel frame.
3 and 4. The ProClip is in place.
2(2)
  • Page 1 1
  • Page 2 2

Brodit 854967 Datasheet

Category
Holders
Type
Datasheet

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI