1. 2.
INSTALLATION INSTRUCTIONS
4.3.
Please read all of the instructions and look at the pictures before attaching the ProClip.
1. Use the enclosed alcohol pad to clean the area where the ProClip is to be installed. Peel off the adhesive tape
cover on the ProClip. Place the lower angled edge of the ProClip against the seam/gap in the dashboard.
2. Press firmly forward on the lower part of the ProClip so the angled edge goes into the seam/gap.
3. Place your index fingers underneath the top part of the ProClip. Pull it upward and then hook the angled edge
over the panel frame edge.
4. The ProClip is in place.
2(2)