Insignia NS-MVTM Quick setup guide

Insignia
Brand
Insignia
Model
NS-MVTM
Type
Quick setup guide

This manual is also suitable for

IMPORTANT SAFETY INSTRUCTIONS
Choking Hazard
WARNING! This product may contain small parts which may be a choking
hazard to children under three years of age. Keep small parts away from
children.
Road Hazard
WARNING! Risk of severe injury or death. This product requires in-car
installation. Do not attempt to install or set up this equipment while your
vehicle is moving.
WARNING! Risk of severe injury or death. Do not install this equipment in a way
that it will obstruct the view of the driver. Some jurisdictions have restrictions
regarding the installation of after-market accessories. Consult and obey the
local laws and regulations.
Notices
• The
vent mount attaches to the horizontal vent louvers found in most vehicles.
Note: Does not work with circular/round type vents found in some vehicles. Removing the
vent mount can be dicult. It is designed to be attached to your car’s vents only once, and will
not transfer easily from car to car.
• Check the state and local laws and ordinances where you drive. Some state
laws prohibit drivers from using mounts on their windshields while operating
motor vehicles. Other state laws allow the mount to be located only in
specic locations on the windshield. It is the user’s responsibility to mount
the device in compliance with all applicable laws and ordinances.
• Insignia does not assume any responsibility for any nes, penalties, or
damages that may be incurred as a result of any state or local law or
ordinance relating to the use of your device.
• Do not install this or any product over an air bag cover or within the air bag
deployment zone. Insignia assumes no responsibility of liability for injury or
death as a result of car crashes and/or air bag deployment.
• Insignia is not responsible for any damages caused to your car, your device,
or yourself due to the installation or use of the mounts.
• Insignia does not assume any responsibility for any nes, penalties, or
damages that may be incurred as a result of any state or local law or
ordinance relating to the use of your device.
• This product is designed for mobile phones only and is compatible with
most smartphones. It may not accommodate the weight of a GPS or other
device. Maximum weight of your device should not exceed 1.77 lbs. (0.8 kg).
FEATURES
Your Insignia car mount securely holds a smartphone to your car air vent or car
window. Make sure that your smartphone is securely fastened to the mount
before you begin your trip.
Caution: This mount is not intended for extreme o-road use.
Before using your new product, please read these instructions to prevent any damage.
PACKAGE CONTENTS
• Car Air Vent Mount
• Car Window Mount
• Holder
• Quick Setup Guide
QUICK SETUP GUIDE
Windshield / Vent Mount
for Smartphones
NSMVTM / NSMWM / NSMVTMC / NSMWMC
Car Window
Mount NS-MWM
360°
swivel
head
Suction lever
Adjustment knob
Flexible arm
Suction cup
Car Air
Vent Mount
NS-MVTM
Car Window Mount
Car Air Vent Mount
NS-MVTM
Car air vent
mount
Release
button
Clamps
Feet
Clips
Kickstand
NS-MWM
Release
button
NS-MVTM_NS-MWM_NS-MVTM-C_NS-MWM-C_18-0360_QSG_V2_EN_Final.ai 1 6/11/2018 10:25:18 AM
Attaching to a car window
1 Clean the window with a clean
cloth.
2 Insert the swivel head into
the slot on the back of the
holder and slide it into place
until it is secure (as shown
below).
3 Remove the clear lm from the
suction cup.
4 Push the suction lever on the
car window mount, press the
suction cup to the desired
location on the clean window,
then press the lever down.
The mount adheres to the
window.
5 Loosen the adjustment knob,
adjust the viewing angle, then
fully tighten the knob.
V2 ENGLISH 18-0360
Caution: Always loosen the
adjustment knob before
changing the viewing angle.
6 Bend the exible arm to
further adjust the viewing
angle.
7 To remove the mount, push
the suction lever, then pull
the suction cup tab.
Caution: Do not adjust your
Insignia car mount while
driving.
Placing a smartphone in the
holder
1 Repeatedly press the release
button on the side of the
holder. The clamps open.
2 Unfold the feet on the bottom
of the holder.
3 Adjust the clamps to t the
width of your smartphone.
4 Place your smartphone in the
holder and close the clamps
by squeezing them together
tightly until your phone is
secure.
Removing your smartphone
from the holder
1 Hold your smartphone and
repeatedly press the release
button on the bottom of the
holder. The clamps open.
2 Remove your smartphone.
Attaching to air vent louvers
1 Insert the car air vent mount
into the slot on the back of the
holder and slide it into place
until it is secure (as shown
below).
2 Align the clip stops with the
edge of an air vent louver,
slowly push the mount back
until it clicks into place, then
release the mount. Make sure
both hooks are attached to
the louver.
Position the kickstand so it
rests against other louvers or
the dash for support.
Caution: Do not adjust your
Insignia car mount while
driving.
ONEYEAR LIMITED WARRANTY
Visit www.insigniaproducts.com for details.
CONTACT INSIGNIA
For customer service, call 1-877-467-4289 (U.S. and Canada) or
01-800-926-3000 (Mexico)
www.insigniaproducts.com
INSIGNIA is a trademark of Best Buy and its aliated companies.
Distributed by Best Buy Purchasing, LLC
7601 Penn Ave South, Richeld, MN 55423 U.S.A.
©2018 Best Buy. All rights reserved.
Made in China
NS-MVTM_NS-MWM_NS-MVTM-C_NS-MWM-C_18-0360_QSG_V2_EN_Final.ai 2 6/11/2018 10:25:18 AM
  • Page 1 1
  • Page 2 2

Insignia NS-MVTM Quick setup guide

Insignia
Brand
Insignia
Model
NS-MVTM
Type
Quick setup guide
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents