2. BLOTZ
  3. B10-CS-263

BLOTZ B10-CS-263 Assembly Instructions

  • Hello! I've examined the instructions for the BLOTZ Tower Block B10-CS-263 model kit. This document provides step-by-step guidance on assembling the ruined middle section of the tower block, detailing the use of glue, a modeling knife and sandpaper. I'm ready to answer your questions about the assembly process and the materials involved.
  • What kind of glue is required for assembly?
    What tools are needed for assembly?
    How to remove sections from sprue?
    What can be used to hold pieces in place while glue dries?
10mm 3x3 Tower Block Middle
(Damaged)
B10-CS-263
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives
with due care and remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to
hold pieces in place while you allow glue to dry.
Ruined Middle-Section
Remove the two floor sections and the tall wall
piece from the sprue.
Glue the floors to the wall as shown, aligning them
using the holes / lugs provided.
Attach the other wall pieces as shown above.
Flip the whole assembly over and glue the support
pieces into position as shown.
Flip it right way up again and glue the sun screen
pieces into place.
/