2. Durabook
  3. R11
R11

Durabook R11 User manual

  • Hello! I've reviewed the user's manual for the DURABOOK Expansion Module LAN. This document provides detailed instructions on installing the LAN expansion module on your R11 rugged tablet and includes details about screws and other parts required for the installation. I understand the process described in the document and am able to answer any questions you may have about it.
  • What should I do if any of the package contents are damaged?
    What should I do before installing any expansion modules?
    How many screws are needed to secure the LAN expansion module cover to the lower case?
©2021 Twinhead International Corp and/or its affiliates. All rights reserved.
1
R11 Rugged Tablet
Expansion Module LAN
P/N: 62+030990+00
Expansion Module LAN
2
Package Contents
If any of following items is damaged, please contact your retailer.
LAN Module Cover
Gasket
Module Bracket
Module FPC
Smart Card Module FPC
Sponges
Screw & O RING
(4+6+3+2)
Standoff (2)
Expansion Module LAN
3
LAN Expansion Module Screws
Screw Name
Quantity
Torque
M2.6X6L
& O RING
4 (cover to lower
case)
2.5 ± 0.3 Kgf-cm
ISOT-M2.0X4L
2 (bracket to lower
case)
2.0 ± 0.3 Kgf-cm
NOTE
The pictures are for reference only, actual items may slightly differ.
Installation
This section will guide you on how to install the expansion modules to your tablet
PC.
Note: Make sure to remove the battery before installing any type of expansion
modules. For more information on how to remove/install the battery, please refer
to the tablet PC service guide.
Installing the LAN Expansion
Module
To install the LAN expansion module, follow the steps below:
1. Remove the screw securing the mylar on the DDR door.
Expansion Module LAN
4
2. Remove the mylars from the DDR door.
3. Attach the expansion sponge and four sponges to the DDR door.
4. Connect the LAN expansion module FPC to the mainboard connector.
5. By aligning with the screw holes, install the LAN expansion module bracket
Expansion Module LAN
5
onto its slot on the lower case.
6. Attach the 2 screws to secure the LAN expansion module assembly to the
lower case.
7. By aligning with the screw holes, place the gasket onto the LAN expansion
module bracket.
Expansion Module LAN
6
8. By aligning with the screw holes, place the LAN expansion module cover on
the top of the installed gasket.
9. Attach the 4 screws to secure the LAN expansion module cover to the lower
case.
10. Install the battery.
Expansion Module LAN
7
LAN Expansion Module Screws
Screw Name
Quantity
Torque
M2.6X6L
& O RING
4 (cover to lower
case)
2.5 ± 0.3 Kgf-cm
ISOT-M2.0X4L
2 (bracket to lower
case)
2.0 ± 0.3 Kgf-cm
Twinhead International Corp.
11F, No.550, Ruiguang Rd., Neihu, Taipei 11492, Taiwan, R.O.C.
/