MODEL
DSL5018EN(1T1R)
Step 3: Setting Up Your Internet Connection
Once the Hardware Setup is completed, proceed to the steps below to establish
the connection with your Internet Service Provider.
Launch an Internet Browser (e.g. Internet Explorer, Google
Chrome), input http://192.168.1.1 on the address bar and press
Enter. You will be redirected to the Web User Interface.
A
Select the Timezone and NTP Server that you would like to set on your
modem router then click Next.
Click the Wizard Tab and follow the step by step guide in setting up
your Internet Connection. Click Next to start.
C
D
Select the WAN Connection type supplied by your Internet Service
Provider then click Next.
E
Your device has been programmed with a default wireless network
name (SSID) and a default wireless password (Passphrase). These
information can also be found underneath your modem router’s
label. Click Next to confirm your settings.
F
On the last page, the summary settings of your modem router
will be displayed. Click the Apply button for the settings to take
effect.
G
NOTE: You may use the default wireless SSID and
Password seen at the bottom of your device if you wish
to proceed without changing the Network name and
password.
Before proceeding to Step 3, please prepare your internet account settings given by your Internet Service Provider. This Easy
Start Guide along with the User Manual which provides a more advanced guide to this product is downloadable on our Aztech
Support Website (www.aztech.com/support).
DSL5018EN(1T1R)
WEB USER INTERFACE
Input admin for the username and admin for the password then
click Login.
B
admin
admin