Lincoln Manufacturing WEDGEMASTER II Operating instructions

Brand
Lincoln Manufacturing
Model
WEDGEMASTER II
Type
Operating instructions
INSTALLATION & OPERATING
INSTRUCTIONS
for
REDCO
®
WEDGEMASTER II™
P/N: 2810320-1 REV: C
Wedgemaster II Ops Manual
2
WARNING AND SAFETY INFORMATION
LIMITED TWO (2) YEAR WARRANTY
Lincoln Foodservice Products, LLC (“Lincoln”) warrants, to the original purchaser for use in the United States of
America, that each new item of Redco food preparation utensils (other than blades) manufactured by it (“Warranted
Product”) is free of defects in material and workmanship under normal use and conditions.
The exclusive remedy available under this Limited Warranty is that Lincoln will, free of charge, but at its option,
subject to, and in accordance with the terms and conditions of the Limited Warranty, repair or replace, for the
original purchaser for use in the United States of America, any Warranted Products or part thereof that proves to be
defective with the same or a similar item or part, if it is returned to Lincoln in accordance with the procedure set out
on the reverse side of this card.
This limited Warranty applies only to the original parts of Warranted Products sold for use in the United States of
America and does not apply to any Warranted Products located outside the United States of America, regardless of
where sold, or to any item or part thereof that has been subjected to accident, casualty, alteration, misuse, or abuse
or if the date of manufacture is altered or removed.
THIS LIMITED WARRANTY DOES NOT APPLY TO BLADES WHICH ARE SOLD COMPLETELY WITHOUT
WARRANTY OR GUARANTEE OF ANY KIND, EXPRESSED OR IMPLIED. THE OBLIGATION OF LINCOLN IS
LIMITED TO THE ABOVE AND, EXCEPT AS EXPRESSLY STATED HEREIN, LINCOLN MAKES NO
GUARANTEES OR WARRANTIES, EXPRESSED OR IMPLIED, INCLUDING, WITHOUT LIMITATION,
WARRANTIES OF FITNESS OR MERCHANTABILITY, WITH RESPECT TO WARRANTED PRODUCTS.
LINCOLN SHALL NOT BE LIABLE FOR SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES OF ANY
KIND. NO ONE IS AUTHORIZED TO MAKE ANY GUARANTEES OR WARRANTIES, EXPRESSED OR
IMPLIED, ON BEHALF OF LINCOLN.
SOME STATES DO NOT ALLOW LIMITATIONS OF IMPLIED WARRANTIES, OR THE EXCLUSION OR
LIMITATION OF INCIDENTAL OR CONSEQUENTIALY DAMAGES IN CONNECTION WITH THE SALE OF
CONSUMER PRODUCTS, CONSEQUENTIALY, IF YOU ARE A CONSUMER, AS THAT TERM IS LEGALLY
DEFINED, THE ABOVE LIMITATION OR EXCLUSION MAY NOT APPLY TO YOU.
TABLE OF CONTENTS
Operating Instructions………………………………………………………………………………………………………….. 3
Cleaning Instructions……………………………………………………………………………………………….………..… 3
Blade Servicing & Replacement……………………………………………………………………………………………… 4
Parts List...………………………………...……………………………….………………………………………………….… 6
Exploded View Drawing…………………………...……..………………………..………………………………………...… 7
!
WARNING
!
THIS MACHINE CONTAINS SHARP BLADES AND CAN CAUSE SERIOUS INJURY OR DEATH IF NOT
HANDLED PROPERLY. ALL OPERATORS OF THIS EQUIPMENT SHOULD READ THIS OPERATION
MANUAL BEFORE OPERATING EQUIPMENT.
IN ORDER TO AVOID DAMAGE TO PEOPLE AND THE APPLIANCE, READ AND FOLLOW THE
MANUFACTURER’S INSTRUCTIONS FOR THE CLEANING OF THIS EQUIPMENT.
Wedgemaster II Ops Manual
3
Blades are sharp and can cause injury. Check machine before using. Be sure machine is clean. Check for
broken, nicked or dull blades and if found, replace blade assembly. Check to be sure Pusher Head Assembly can
move freely. Lubricate if necessary using a light coating of mineral oil, Petrol Gel or food grade lubricant. DO NOT
LUBRICATE WITH COOKING OIL AS IT WILL BECOME STICKY.
OPERATION INSTRUCTIONS
1. Place machine on a level counter or table.
2. When wedging lemons or limes, it is best to cut off both ends of the fruit.
3. When wedging tomatoes, use a Tomato King Scooper to remove the stem scar.
4. Raise the head of the Wedgemaster II with your right hand. Center the product that you are going to cut on
the center spike, which is the middle of the blade assembly.
5. Remove your hand away from the blade assembly. With a strong, quick, downward thrust of the head
assembly with your right hand, force the product through the blade to make perfect wedges.
6. Clean and lubricate your machine immediately.
CLEANING INSTRUCTIONS
1. Acidic foods can make the blades dull and corrode prematurely. ALWAYS clean the Wedgemaster II after
every use.
2. After use, remove the pusher assembly and base assembly and clean with warm, soapy water. Rinse with
hot water and let air dry. DO NOT wipe the blades. A brush and sprayer may be used to clean the blades.
3. The Wedgemaster II may be machine washed with mild detergents and with care to protect the blades.
!
CAUTION:
BLADES ARE SHARP AND CAN CAUSE INJURY. NEVER USE MACHINE UNLESS
ALL RUBBER FEET ARE IN PLACE.
!
CAUTION:
FOOD ACIDS WILL MAKE BLADES DULL AND CORRODE THE METAL.
ALWAYS CLEAN THIS FOOD PREPARATION MACHINE IMMEDIATELY
AFTER EVERY USE!
!
DANGER:
THIS MACHINE CONTAINS SHARP BLADES AND CAN CAUSE SERIOUS
INJURY OR DEATH IF NOT HANDLED PROPERLY. ALL OPERATORS OF
THIS EQUIPMENT SHOULD READ THIS OPERATION MANUAL BEFORE
OPERATING EQUIPMENT.
!
CAUTION:
PRIOR TO USING YOUR NEW EQUIPMENT, IT IS IMPORTANT TO CLEAN
THE UNIT. WASH NEW BLADES WITH WARM SOAPY WATER AND RINSE
THOROUGHLY TO REMOVE THIN PROTECTIVE OIL FILM. LET AIR DRY.
!
CAUTION
!
Wedgemaster II Ops Manual
4
BLADE SERVICING AND REPLACEMENT
If the machine no longer slices cleanly or without damage, the blades could be dull and need to be replaced.
Broken, bent, nicked, or dull blades must be replaced immediately. Change the complete assembly.
1. Allow yourself ample room to work on a flat, dry surface.
2. Turn machine on its side and remove the Pusher Head Assembly.
3. Remove the two (2) Blade Screws from the bottom of the Base Assembly. Carefully remove the blade
assembly by gently pushing up from underneath the Base Assembly. This will remove the blade assembly
from the unit.
4. Install new blade assembly by carefully placing it inside the top of the Base Assembly. NEVER push down
on blade assembly when inserting into the base! Once in place, insert the two (2) blade screws until tight.
DISPOSE OF USED BLADES AND BLADE ASSEMBLIES!
!
DANGER:
HANDLE WITH EXTREME CARE AS BLADES ARE SHARP AND CAN CAUSE
INJURY OR DEATH IF NOT HANDLED PROPERLY. ALL OPERATORS OF
THIS EQUIPMENT SHOULD READ THIS OPERATION MANUAL BEFORE
OPERATING EQUIPMENT.
!
CAUTION:
PRIOR TO USING YOUR NEW EQUIPMENT, IT IS IMPORTANT TO CLEAN
THE UNIT. WASH NEW BLADES WITH WARM SOAPY WATER AND RINSE
THOROUGHLY TO REMOVE THE THIN PROTECTIVE OIL FILM.
Wedgemaster II Ops Manual
5
This page intentionally left blank.
Wedgemaster II Ops Manual
6
SPARE PARTS
LETTER
PART
NUMBER
DESCRIPTION
A 379107 Pusher Assembly, 6 / 12 Section
B 379108 Pusher Assembly, 4 / 8 Section
C 379109 Base Assembly
D 704 Blade Assembly, 4 Section
E 706 Blade Assembly, 6 Section
F 708 Blade Assembly, 8 Section
G 712 Blade Assembly, 12 Section
H 305 ‘O’ Ring
I 379103 Foot Cover
Wedgemaster II Ops Manual
7
EXPLODED VIEW – WEDGEMASTER II
A, B
D, E, F, G
H
C
I
Wedgemaster II Ops Manual
8
Lincoln Foodservice Product, LLC
1111 North Hadley Road
Fort Wayne, Indiana 46804
United States of America
Telephone: (260) 459-8200
U.S. Fax: (888) 790-8193
Int’l Fax: (260) 436-0735
Technical Support Hotline: (800) 678-9511
www.lincolnsmallwares.com
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8

Lincoln Manufacturing WEDGEMASTER II Operating instructions

Brand
Lincoln Manufacturing
Model
WEDGEMASTER II
Type
Operating instructions
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents