Cascadia OF50511OA Installation guide

Cascadia
Brand
Cascadia
Model
OF50511OA
Type
Installation guide

Cascadia OF50511OA is a ceiling light fixture designed for indoor use. It requires assembly and installation by a qualified electrician, following the instructions provided in the manual. The fixture features a mounting strap that attaches to an outlet box, and a ceiling pan that is attached to the mounting strap. The fixture includes two sizes of flat glass panels that are secured with "S" clips. The fixture requires eight light bulbs, which are not included. The manual warns to turn off power at the main fuse or circuit breaker box before installing or servicing the fixture.

Cascadia OF50511OA is a ceiling light fixture designed for indoor use. It requires assembly and installation by a qualified electrician, following the instructions provided in the manual. The fixture features a mounting strap that attaches to an outlet box, and a ceiling pan that is attached to the mounting strap. The fixture includes two sizes of flat glass panels that are secured with "S" clips. The fixture requires eight light bulbs, which are not included. The manual warns to turn off power at the main fuse or circuit breaker box before installing or servicing the fixture.

071220
1. Attach the nipple to the mounting strap, then secure it
with a washer and hex nut.
2. Attach the mounting strap to the outlet box by using two
mounting screws.
3. Unscrew the bolt nuts and remove the frame away from
the ceiling pan.
4. Gently place a bigger flat glass into the bottom of the interior
frame, secure it by placing 8 pieces of “S” clips (two on each
side of the interior frame) into position. (See Fig.1 & Fig.2)
5. Gently place four smaller flat glasses into four sides of the
interior frame into position as shown in Fig.5. With
one side locating into the slot of “S” clip, secure the
flat glasses by pressing the clips. (See Fig.3 & Fig.4)
6. Pull out the outlet wires and house grounding wire
from the outlet box. Make wire connections using the
wire nuts:
---The black wire from the fixture to the black wire
from the power source.
---The white wire from the fixture to the white wire
from the power source.
---Attach the fixture grounding wire to the mounting
strap with the green grounding screw. Then
connect it to the house grounding wire with a
wire nut.
Carefully put the wires back into the outlet box.
7. Attach the ceiling pan to the mounting strap by inserting
the nipple, then secure it with the end cap.
CAUTION: With silicone caulking compound, caulk completely
around where back of ceiling pan meets with the ceiling surface
to prevent water from seeping into the outlet box.
8. Install bulbs (not included). See relamping label at socket area or
packaging for maximum allowed wattage.
9. Restore the frame back to the ceiling pan using two bolt nuts.
10. Turn on the power at the main fuse or circuit breaker box.
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT
BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THIS INSTRUCTION.
OF50511
House Grounding Wire
Hex Nut
Washer
Wire Nut
Mounting Strap
Green Grounding Screw
Mounting Screw
Fixture Grounding Wire
Nipple
Fixture Wire
Outlet Box
Ceiling Pan
Socket
End Cap
Frame
Bolt Nut
Fig. 5
Fig.4Fig.3
Fig.2Fig.1
Frame
Flat Glass
Flat Glass
Bigger Flat Glass
Frame
Frame
Small Flat Glass
Frame
Clip
Frame
Slot of “S” Clip
“S” Clip
  • Page 1 1

Cascadia OF50511OA Installation guide

Cascadia
Brand
Cascadia
Model
OF50511OA
Type
Installation guide

Cascadia OF50511OA is a ceiling light fixture designed for indoor use. It requires assembly and installation by a qualified electrician, following the instructions provided in the manual. The fixture features a mounting strap that attaches to an outlet box, and a ceiling pan that is attached to the mounting strap. The fixture includes two sizes of flat glass panels that are secured with "S" clips. The fixture requires eight light bulbs, which are not included. The manual warns to turn off power at the main fuse or circuit breaker box before installing or servicing the fixture.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents