Brodit ProClip Datasheet

Category
Holders
Type
Datasheet

This manual is also suitable for

1 May, 2013, www.brodit.com, © 2013 Brodit AB
Product 853138
853138 ProClip
Angled mount, High, ONLY for vehicles with cup holder
The ProClip is a mounting bracket for the vehicle’s dashboard. Onto the ProClip you can install e.g. a holder for
your mobile phone or PDA or a handsfree set etc. Safe and convenient -always within easy reach. The ProClip is
car specific and easy to install. The installation is quick, no special tools or dismantle of the dashboard is required
and it will not damage the interior of the vehicle. Made in black ABS plastic. Comes with detailed instructions.
EAN: 7320288531380
Item no 853138 fits:
Subaru Forester 03-07 (For Europe)
Subaru Forester 03-07 (For USA)
1(2)
1. 2.
INSTALLATION INSTRUCTIONS
4.3.
Attention! Read all instructions and look at the pictures before attaching the ProClip.
1. Press the thin end of the enclosed gap opener into the gap between the stereo and the surrounding panel
frame to widen the gap. Peel off the cover of the adhesive tape on the ProClip.
2. Press the lower part of the ProClip, with adhesive tape, into the gap next to the gap opener. Pull out the gap
opener.
3. Press the grooved edge on the upper part of the ProClip into the gap between the air vent panel frame and the
dashboard. Press firmly forward until you see or hear/feel it snaps into place.
4. The ProClip is in place.
2(2)
  • Page 1 1
  • Page 2 2

Brodit ProClip Datasheet

Category
Holders
Type
Datasheet
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI