Brodit 855021 Datasheet

Product 855021

855021 ProClip

Center mount

The ProClip is a mounting bracket for the vehicle’s dashboard. Onto the ProClip you can install e.g. a holder for

your mobile phone or PDA or a handsfree set etc. Safe and convenient -always within easy reach. The ProClip is

car specific and easy to install. The installation is quick, no special tools or dismantle of the dashboard is required

and it will not damage the interior of the vehicle. Made in black ABS plastic. Comes with detailed instructions.

EAN: 7320288550213

Item no 855021 fits:

Toyota Highlander 14-15 (For USA)

1(2)

1. 2.

INSTALLATION INSTRUCTIONS

4.3.

Please read all of the instructions and look at the pictures before installing the ProClip.

1. Press the thin end of the first enclosed gap opener into the gap between the padded dashboard ledge and the

console panel frame, to widen the gap. Press the second gap opener into the gap between the air vent panel

frame and the padded dashboard edge.

2. Use the enclosed alcohol pad to clean the area where the ProClip is to be installed. Peel off the cover of

adhesive tape on the ProClip. Press firmly forward in the center of the ProClip so the lower grooved edge goes

into the gap next to the gap opener. Press until you see or hear/feel it click into place.

3. Press down on top of the ProClip with your fingers and firmly forward with your thumb so the grooved edge on

the top part of the ProClip goes into the gap next to the gap opener. Press until you see or hear/feel it click into

place. Pull out the gap openers.

4. The ProClip is in place.

2(2)

Download PDF