Brodit 854774 Datasheet

Category
Holders
Type
Datasheet
28 January, 2015, www.brodit.com, © 2015 Brodit AB
Product 854774
854774 ProClip
Center mount
The ProClip is a mounting bracket for the vehicle’s dashboard. Onto the ProClip you can install e.g. a holder for
your mobile phone or PDA or a handsfree set etc. Safe and convenient -always within easy reach. The ProClip is
car specific and easy to install. The installation is quick, no special tools or dismantle of the dashboard is required
and it will not damage the interior of the vehicle. Made in black ABS plastic. Comes with detailed instructions.
EAN: 7320288547749
Item no 854774 fits:
Acura RDX 13-15 (For USA)
1(2)
1. 2.
INSTALLATION INSTRUCTIONS
4.3.
Please read all of the instructions and look at the pictures before attaching the ProClip.
1. Press the thin end of the enclosed gap opener into the gap between the air vent frame and the padded part of
the dashboard, to widen the gap. Start with the left corner and press the grooved edge on the lower part of the
ProClip into the gap next to the gap opener.
2. Press forward on the right lower part of the ProClip to press the remaining part of the grooved edge into the
gap. Pull out the gap opener.
3. Press the gap opener into the gap between the air vent frame and the padded part of the dashboard. Press
forward on the upper part of the ProClip with your right hand. Press until you see or hear/feel the angled edge
click into the gap next to the gap opener. Press down on top of the ProClip with you left hand so to make sure the
angled edge is all the way into the gap. Pull out the gap opener.
4. The ProClip is in place.
2(2)
  • Page 1 1
  • Page 2 2

Brodit 854774 Datasheet

Category
Holders
Type
Datasheet

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI