Brodit 654756 Datasheet

Category
Holders
Type
Datasheet
26 January, 2015, www.brodit.com, © 2015 Brodit AB
Product 654756
654756 ProClip
Angled mount
The ProClip is a mounting bracket for the vehicle’s dashboard. Onto the ProClip you can install e.g. a holder for
your mobile phone or PDA or a handsfree set etc. Safe and convenient -always within easy reach. The ProClip is
car specific and easy to install. The installation is quick, no special tools or dismantle of the dashboard is required
and it will not damage the interior of the vehicle. Made in black ABS plastic. Comes with detailed instructions.
EAN: 7320286547567
Item no 654756 fits:
Audi A1 12-15 (For all countries)
1(2)
1. 2.
INSTALLATION INSTRUCTIONS
4.3.
Please read all of the instructions and look at the pictures before attaching the ProClip.
1. Press the thin ends of the enclosed gap openers into the gap between the stereo and the surrounding frame,
to widen the gap (place one to the left of the stereo and the other over the stereo) Press the lower corner of the
grooved vertical part of the ProClip into the gap above the left gap opener.
2. Press forward on the ProClip so all of the vertical grooved edge goes into the gap.
3. Press forward on the upper part of the ProClip so the grooved horizontal part goes into the gap next to the gap
opener. Pull out the gap openers.
4. The ProClip is in place.
2(2)
  • Page 1 1
  • Page 2 2

Brodit 654756 Datasheet

Category
Holders
Type
Datasheet

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI