2. Rugged Ridge
  3. 11232.23

Rugged Ridge 11232.23, 11232.24 Installation guide

  • Hello! I've reviewed the installation instructions for the Rugged Ridge LED Fog Light Brackets. This document details the steps for mounting both round and square LED fog lights to your vehicle's bumper, including hardware and mounting options. I'm ready to answer any questions you may have about the installation process or the product itself.
  • What LED brand is recommended for use with these brackets?
    Is a spacer required for mounting all LED lights?
    What is the first step in installing the LED Fog Light Brackets?
460 Horizon Drive #400 | Suwanee, GA 30024 USA | www.omix-ada.com | Copyright © 2013 Omix-Ada®, Inc.
Page 1/2
LED FOG LIGHT BRACKETS
OMIX-ADA® TECHNICAL SUPPORT
PHONE: M-F 8am - 5pm EST 1-800-449-6649 | EMAIL: [email protected]
FOR WARRANTY INFORMATION VISIT: www.Omix-Ada.com
1. LED Fog Light Bracket (2)
2. L-Bracket (2)
3. Hex Bolt (2)
4. Locknut (2)
5. Spacer (2)
6. Flat washer (4)
7. Tapping Screw (8)
3. Mount LED to LED Fog Light Bracket using supplied hardware and
Spacer.
4. Slide LED forward to set desired depth for bumper installation and
tighten.
Spacer is required for mounting Rugged Ridge LEDs and
may not be required with other brands. Use spacer as needed.
1. Remove Bumper (Refer to the factory manual or Instructions for
your aftermarket Bumper)
2. Remove fog lights from bumper.
11232.23 : LED Fog Light Brackets - Round
11232.24 : LED Fog Light Brackets - Square
NOTICE
Contents:
!
LED Fog Light Brackets are compatible with most LED designs; however, we recommend using Rugged
Ridge LEDs for best results.
NOTICE
For use with Rugged Ridge LEDs
!Minor relocation of vacuum pump may be required for installation on 2012 and newer Jeep Wrangler
vehicles.
NOTICE
460 Horizon Drive #400 | Suwanee, GA 30024 USA | www.omix-ada.com | Copyright © 2013 Omix-Ada®, Inc.
Page 2/2
LED FOG LIGHT BRACKETS
8. Secure LED Fog Light Brackets to bumper using supplied Tapping
Screws. Adjust LED projection angle and tighten.
9. Reinstall bumper.
For use with non-Rugged Ridge LEDs
5. Mount LED to L-Bracket
6. Mount L-Bracket to LED Fog Light Bracket.
7. Adjust LED to desired position for bumper installation and
tighten.
Hardware orientation may be reversed for clearance
depending on bumper/ light combination.
!
NOTICE
OMIX-ADA® TECHNICAL SUPPORT
PHONE: M-F 8am - 5pm EST 1-800-449-6649 | EMAIL: [email protected]
FOR WARRANTY INFORMATION VISIT: www.Omix-Ada.com
11232.23 : LED Fog Light Brackets - Round
11232.24 : LED Fog Light Brackets - Square
/