2. Rugged Ridge
  3. 17752.05

Rugged Ridge 17752.05, 17751.52, 17752.01, 17752.03, 17752.04, 17752.06, 17752.08, 17752.09, 17752.10 Installation guide

  • Hello! I've reviewed the Rugged Ridge Synthetic Air Filter cleaning instructions. This manual outlines how to properly clean your reusable air filter using a mild degreaser and water. It's important to avoid high-pressure water and air when cleaning this filter, and also that no oil is required. I'm ready to answer your questions about the filter and its maintenance.
  • Can I use compressed air to clean the filter?
    Is it ok to use high pressure water to clean the filter?
    Do I need to apply oil to the filter after cleaning?
    How long should I allow cleaner to soak in?
RUGGED RIDGE SYNTHETIC AIR FILTER CLEANING INSTRUCTIONS
Step 1. Remove your re-usable air lter from your factory air box or Rugged Ridge air
intake system. The factory air box and or area around the lter will need to
be cleaned also.
Step 2. Lightly shake or tap the lter to remove large debris and excess dirt. A soft
bristle paint brush may be needed to dislodge debris from the pleats in the
lter.
Step 3. Clean lter with dish soap or a mild degreaser spray and water. Allow cleaner
to soak in to penetrate dirt and debris. Do not allow cleaner to dry on lter.
No more than 5 to 10 minutes.
Step 4. Thoroughly rinse lter with clean water. Do not use high pressure water to
rinse. Allow air lter to air dry completely. For best results place air lter in
open sunlight. Once the lter is completely dry re-install in your vehicle.
NOTICE ! Do not use compressed air or high pressure water to clean lter. Do not expose lter to open
heat or ame to dry. Excessive force will damage the lter. Oil is not needed for lter.
REV 09/22
For Technical Assistance Contact: Phone: 1-800-449-6649
OMIX-ADA Tech Support Email: techsupport@omix-ada.com
Web: www.Omix-Ada.com
/