Rugged Ridge 17752.07 Installation guide

  • I have reviewed the document provided; it contains instructions for cleaning a Rugged Ridge Reusable Air Filter. The instructions details the steps for cleaning, rinsing, and drying the filter, emphasizing the avoidance of high-pressure water and heat. I am here to answer any questions you may have about the cleaning process.
  • What should you not use to clean this filter?
    What should you not use to dry this filter?
    How long should the cleaner soak on the filter?
    Is oil needed for the filter?
RUGGED RIDGE SYNTHETIC AIR FILTER CLEANING INSTRUCTIONS
Step 1. Remove your re-usable air lter from your factory air box or Rugged Ridge air
intake system. The factory air box and or area around the lter will need to
be cleaned also.
Step 2. Lightly shake or tap the lter to remove large debris and excess dirt. A soft
bristle paint brush may be needed to dislodge debris from the pleats in the
lter.
Step 3. Clean lter with dish soap or a mild degreaser spray and water. Allow cleaner
to soak in to penetrate dirt and debris. Do not allow cleaner to dry on lter.
No more than 5 to 10 minutes.
Step 4. Thoroughly rinse lter with clean water. Do not use high pressure water to
rinse. Allow air lter to air dry completely. For best results place air lter in
open sunlight. Once the lter is completely dry re-install in your vehicle.
NOTICE ! Do not use compressed air or high pressure water to clean lter. Do not expose lter to open
heat or ame to dry. Excessive force will damage the lter. Oil is not needed for lter.
REV 09/22
For Technical Assistance Contact: Phone: 1-800-449-6649
OMIX-ADA Tech Support Email: techsupport@omix-ada.com
Web: www.Omix-Ada.com
/