BLOTZ B28-SF-236 Assembly Instructions

Type
Assembly Instructions
28mm Power Bank
B28-SF-236
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and
remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in
place while you allow glue to dry.
Take the two wall sections, the top lozenge and the
six end pieces from the sprue (shown above).
Glue the walls back-to-back. Turn the top piece over
and attach the walls. Glue the six end pieces into
position.
Guide three of the end pieces into the holes on the
smallest base lozenge along with two of the wall
lugs. Gently align the other three end pieces and the
base should slot into place.
Attach the other two base pieces as shown above.
Take the saw-blade pieces as shown above from the
sprue.
Starting at one end of the wall, glue the saw-blade
pieces into place. Repeat this for the other side of
the model.
Take the two cap pieces.
Glue them into place as shown above.
The finished model.
Painting
Once built, we sprayed our model with a black car undercoat aerosol primer and after that had dried we painted all the
saw-tooth sections with a dark green colour followed by a drybrush of a bright green to pick out the raised edges.
The base and top had the edges carefully highlighted with a pale grey.
  • Page 1 1
  • Page 2 2

BLOTZ B28-SF-236 Assembly Instructions

Type
Assembly Instructions

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI