ACCESSORY INSTALLATION
INSTRUCTIONS
BENCH SEAT CUSHION
Installation Instructions for the 130, 150 & 170 Super Sport
Issue Date
05/11/2010
Rev:B
PROCEDURE NO.
AI-MS-001
8. PROCEDURE
8.1. Center the cushions on the bench between the
outside edges of the bench and the cup holders.
8.2. Wrap the canvas flaps under the bench.
8.2.1. Using the pencil, make a mark at the point
where the snaps contact the underside of
the bench.
NOTE: There are three places forward and
three places aft that should be
marked.
8.3. Using the drill with 1/8” drill bit, drill the bench at the
marks made in the previous step.
NOTE: Drill only deeply enough to penetrate the
fiberglass layer. DO NOT drill into or
through the core material.
Page 2 of 3