8.
PROCEDURE
8.1
Place the seat on the bench making
sure the front edge of the seat aligns with
the front edge of the bench.
8.2
Using the pencil, mark the bench at each of the posts
under the seat.
8.2.1.
Remove the seat from the bench.
8.3
Using the drill with the 3/8” drill bit, drill through the bench
At each of the marks made in the previous step.
To avoid throttle interference when
operating the boat leave 1 ¾” space
between the throttle and the seat
when installing on the 130SS.
Center the seat on the bench when
installing on the 160SS.