Spacers are installed on the CN3 terminal holder to allow for optimum fit of the
holder on the 6822 portable printer.
To install the spacers
1 Center a spacer on each mounting post and press firmly to seat.
2 Align the terminal holder on the printer and insert the screws in the four
mounting holes.
3 Using a Phillips screwdriver, tighten the screws to 0.45 to 0.68 Nm (4 to 6 in-lb).
CN
3
Terminal Holder Spacer Installation
Instructions
Screw (4 places)
Spacer
(4 places)
Worldwide Headquarters
6001 36th Avenue West
Everett, Washington 98203
U.S.A.
tel 425.348.2600
fax 425.355.9551
www.intermec.com
©
2008 Intermec Technologies
Corporation. All rights reserved.
CN3 Terminal Holder Spacer Installation Instructions
*943-197-001*
P/N 943-197-001
/
