2. BST KOREA
  3. ID-100 ID Reader Setting

BST KOREA ID-100 ID Reader Setting User guide

  • Hello! I have reviewed the BST KOREA Inc. ID Reader Setter Guide for the ID-100 model. This guide explains how to use the SETTER program to configure the reader, including managing MSR track, i-button, beep settings, and start/end codes. I'm ready to answer any questions you might have about these settings and their configurations.
  • How to read current settings from the reader?
    How to save changes to the reader settings?
    How to revert to default settings?
BST KOREA Inc.
Best Solution & Technology
www.bstkr.com Page: 1 / 2
ID Reader Setter Guide
Applied model : ID-100
BST KOREA Inc.
Best Solution & Technology
www.bstkr.com Page: 2 / 2
1. Download Setter Program from below website.
http://www.bstkr.com/?page_id=1286&uid=36&mod=document&pageid=1
2. Run the SETTER program.
** The reader must be connected to the system.
3. UI Guide
- How to change the setting
1) Click Read button for reading current setting status from reader.
2) Modify about check box and Code.
“ Track, Beep sound, Start/end code, Line enter ”
3) Click Write Button to save change status.
- How to change the default.
1) Click Clear button.
** Default setting : enable all of MSR Track and i-button, Beep on, Line change.
➢ If the set is ok and connect to reader properly,
Beep sound alarm for each step when click the button(Read, Write, Clear)
Select
MSR Track
Beep sound
On/Off
i-Button
Add start suffix
Add and suffix
Line change
For each track
/