Anova BRP300 Installation guide

Brand: Anova

Model: BRP300

Type: Installation guide

anovafurnishings.com

888.535.5005 tel

TOOLS NEEDED: HARDWARE NEEDED:

Installation Instructions

Step-by-Step Installation Sequence

Hammer DrillHammer

Pencil

9/16"Wrench

Wire Brush

Level

Safety Glasses

Traditional BRP Bike Racks

Optional: (4 or 6) 3/8"

Rubber Washers

90130A050

(4 or 6) 3/8" x 5" 18-8

Stainless Steel Stud Anchors

92188A203

Masonry Drill Bit Set

3/16", and 3/8"

Product requires assembly before installation.

Examine the footing or slab for damage or defects. The footing or slab should be reinforced concrete rated at a

3,000 psi minimum and be cured for at least 28 days prior to the installation of the bike rack.

CAUTION: Oversized holes and holes drilled too deep in the concrete will make it dicult to set the anchor.

Installation Instructions

Step-by-Step Installation Sequence

Evacuate debris from mounting holes using compressed air and a steel wire

brush. This will create a clean environment for the anchor system.

Locate an anchor and adjust the nut so it is ush with the top of the anchor to

protect the threads from being damaged. Insert the anchor into the hole.

Use the hammer to x the anchor into the drilled hole by giving it several

hammer blows.

Repeat steps 3 - 6 until all anchors are installed.

Care should be given to avoid rubbing the powder coating o the foot. A

3/8" rubber washer is a suitable replacement option. Mount the bench to the

ground by placing a washer and a nut onto each anchor. Leave the hardware

nger tight until all of them have been installed. Verify that the bench is level

before tightening the anchors. Tighten all of the hardware with a 9/16" wrench.

Remove the nuts and washers o of the anchors. Align the mounting holes of

the bench over top of the anchors and slide it down into place.

It is recommended that you start holes in sequential order from the

smaller to the larger drill bits to avoid oversized holes or holes drilled too

deep. Begin with 3/16" diameter drill bit followed by the 3/8" diameter bit.

Place bench in the desired location. Mark the location of the holes with a

pencil. To verify the alignment of the anchor markings you may reference

page 3.

8.28.1

Traditional BRP Bike Racks

Note: Please contact Customer Care at 1-866-797-1761 when ordering replacement parts.

Installation Instructions

10/03/2018

Rally & Ultra Benches

FOOT MOUNT SIZE CHART

SKU # Width Length

L1420

F1365 16.375" 76.785"

F1361 16.375 53.035"

D1027

D1027COM

L1337

C1337

19.375" 76.660"

D1360

F1360

F1027

19.375 76.688

F1026

D1026

L1343

F1389

19.375 52.785

D6002

D6002COM 21.500" 76.188"

D6003 21.500" 52.316"

D6011 22.025" 76.125"

Width

Length

Ø.50" (4 PLCS)

Anova BRP300 Installation guide

Anova BRP300 Installation guide

Anova BRP300 Installation guide

Related papers

Other documents