English-1
Style A
© 2011 Midmark Corp. | 60 Vista Drive Versailles, OH 45380 USA | 1-800-643-6275 | 1-937-526-3662 |
midmark.com
003-2402-00 Rev. A (8/23/2011)
Wet or Dry Treatment Table Installation
Casework (Recessed Mount)
Note
Midmark recommends to use 2 installers for this procedure.
Installer may bolt table to cabinet.
Wet Table Dimensions
Attention
Midmark recommends using a licenced
professional to install required plumbing.
Dry Table Dimensions
Applies to Models:
8003 (all)
8007 (all)
Special Tools:
none
VA1517-1i
VA1402i
Step 1: Install brackets.
English-2
Style A
© 2011 Midmark Corp. | 60 Vista Drive Versailles, OH 45380 USA | 1-800-643-6275 | 1-937-526-3662 |
midmark.com
VA1701i
Recessed Installation
Step 4: Use dimensions shown to mark top and bottom
hole locations on the back panel of table.
Drill 7/32” holes on marked locations.
Measure, Mark, Drill Hole Locations
7/32” Drill
Step 6: Move table into mounting position.
Install table to brackets through door opening.
Note: Install table bracket to cabinet bracket on door/drawer side.
Install through drilled holes on back panel to cabinet bracket.
Step 5: Verify plumbing connections will
reach proper location before
performing Step 6.
English-3
Style A
© 2011 Midmark Corp. | 60 Vista Drive Versailles, OH 45380 USA | 1-800-643-6275 | 1-937-526-3662 |
midmark.com
1 1/2" (max.)
(3.8 cm)
LOWER
TABLE
TABLE
RAISE
Step 4: To install faucet with or without
sprayer follow the manufacturer’s
instructions.
Step 5: Install drain, tail pipe and hair trap.
Note: The debris trap is not intended to replace a P-trap. The
debris trap is a plumbing device that has a removable strainer
intended for installation between the tub drain and before the
standard P-trap. Midmark does not supply the P-trap.
Drain
Plumbing Installation
P-Trap
NOT Supplied
To level table (if needed)...
Step 2: Pull drawer up and out to
remove from slides.
To level table (if needed)...
Step 1: Pull drawer out then carefully pull
outside of drawer out to release
drawer slide tabs from drawer.
To level table (if needed)...
Step 3: Level table
and re-install
drawer (s).
/