2. Baby Lock
  3. BLL-EF

Baby Lock BLL-EF Operating instructions

  • Hello! I've reviewed the instructions for the Baby Lock Embroidery Foot BLL-EF. This document outlines the steps for safely replacing your embroidery foot, with key emphasis on using the correct "U" foot to prevent needle damage, and proper installation of the foot. I'm here to answer any questions you may have regarding this replacement process, or any other aspect of the document.
  • What is the purpose of the Embroidery Foot?
    What should I do before attaching a presser foot?
    Which embroidery foot should I use?
800-422-2952 www.babylock.com
The Embroidery Foot was created as an embroidery foot
replacement. If you have misplaced the foot included with your
computerized Baby Lock embroidery machine, don’t worry – this
is the foot you need.
INSTRUCTIONS:
Note: When attaching a presser foot, always press in the
operation panel. You may accidentally press the “Start/Stop”
button and possibly cause injury. Be sure to use embroidery foot
“U” when doing embroidery. Using another presser foot may
cause the needle to strike the presser foot, causing the needle to
bend or break and possibly cause injury.
1. Press the “Needle Position” button to raise the needle.
2. Press
The Presser foot/Needle exchange screen appears and all keys
and operation buttons are locked.
Embroidery Foot
(BLL-EF)
Instructions
Baby Lock
Sewing Accessories
LNIS-BLL-EF
3. Raise the presser foot lever.
4. Press the black button on the presser foot holder to
remove the presser foot.
5. Use the included screwdriver to loosen the presser
foot holder screw, and then remove the presser foot
holder.
LNIS-BLL-EF.indd 1 3/5/09 7:52:02 AM
800-422-2952 www.babylock.com
6. Attach embroidery foot “U” so that the presser foot
holder screw fits into the notch in the foot.
* Make sure that embroidery foot “U” is vertical when it
is installed.
7. Hold the embroidery foot in place with your right
hand, and then use the included screwdriver to
securely tighten the presser foot holder screw. If the
screw is loose, the needle may strike the presser foot
and possibly cause injury.
8. Press , or in the screen
that appeared. All keys and operation buttons are
unlocked, and the previous screen is displayed.
LNIS-BLL-EF.indd 2 3/5/09 7:52:04 AM
/