2. Knoll
  3. 1B63344H01
1B63344H01

Knoll 1B63344H01 User manual

  • Hello! I've reviewed the installation instructions for the Knoll Calibre Composite Counterweight Kit. The document provides a step-by-step guide on how to install the ballast plates, flat bracket, and 'L' brackets to enhance the stability of your cabinet. I am ready to answer any questions you have about the installation process or the components included in this kit.
  • What is the first step in installing this kit?
    What should I do before removing the bottom drawer?
    How should I secure the ballast plates?
Installation Instructions
© Knoll, Inc. 2022 Part Number: 1B63344H01
1. Remove drawers. (Fig. 1)
Starting with the top drawer, fully extend
drawer out. Depress two slide retention nger
tabs (rectangular shape) from inside drawer
to disengage drawer from slides. Lift and pull
drawer off slides. Before removing the bottom
drawer, mark the case rear reinforcement with
a line at the top rear of the bottom drawer.
Note: Remove all drawers to allow for ballast
plate (counterweight) installation.
Caution: Do not over-depress slide
retention nger tabs, deection may occur.
2. Install ballast plates. (Fig. 2)
Place one ballast plate vertically on each side
of lock channel. Adjust plates at against
back and toward middle of cabinet for best
positioning.
3. Secure ballast plates to cabinet. (Fig. 3)
Position at bracket 1/2" to 1" above line on
back reinforcement from step 1, and at center
of cabinet. Fasten with (2) #10 self drilling
screws. Next, position (2) "L" brackets at
same level as at bracket and (2) "L" brackets
at bottom plate corners. Secure with
(4) #10-24 x 3/8" thread rolling screws.
Note: Be sure to install all brackets and
hardware.
4. Re-install drawers.
Note: Make sure drawer front and rear
mounting tabs engage slide tab inserts
and slide retention nger tabs snap into
rectangular openings in drawers.
Calibre™ Composite Counterweight Kit
DISASSEMBLY FOR RECYCLING
Materials Identication and Segregation:
Where possible plastic components are marked
with ASTM recycling codes. Use these codes to
identify material type for recycling. Non-marked
components should be treated as mixed plastic.
Ferrous metals can be identied using a small
magnet for recycling. Non-ferrous metals should
be separated and recycled separately.
To disassemble product, reverse the
above installation steps.
Part List:
Ballast plates (2)
Flat bracket (1)
"L" brackets (4)
#10-24 x 3/8" Thread rolling screws (4)
#10-16 x 5/8" Self drilling screws (2)
Lateral le
Slide
Drawer
Mounting tab
(2) Slide retention nger tabs
(depress from inside drawer)
(Fig. 1)
Ballast plate
Back reinforcement
(Fig. 2)
Flat bracket
Slide tab inserts
(2) #10-16 x 5/8"
high/low thread screws
(4) #10-24 x 3/8"
thread rolling screws
(4) "L" brackets
(Fig. 3)
/