2. BLOTZ
  3. B00-RT-408

BLOTZ B00-RT-408 Assembly Instructions

  • I have reviewed the instructions for the Racing Gate B00-RT-408 model. This document provides guidance on assembling the gate using glue, sandpaper, and a modeling knife. It outlines the steps needed to complete each gate, including adding connectors, feet, and numbered signs. I'm ready to answer your questions about the model and its assembly.
  • What type of glue is required?
    What tool is needed to remove sections from the sprue?
    What can be used to hold pieces in place while the glue dries?
Racing Gates
B00-RT-408
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and
remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place
while you allow glue to dry.
Each game is formed from the pieces shown
above.
Glue the two connectors to the gantry.
Add a foot at each end.
The numbered signs slot into place – one on each side
of the gantry.
The four completed gates.
The gates once painted.
/