2. BLOTZ
  3. B28-SFW-102

BLOTZ B28-SFW-102 Assembly Instructions

  • Hello! I've reviewed the instructions for assembling the BLOTZ Sci-Fi Walls, specifically models B28-SFW-005, B28-SFW-006, and B28-SFW-007. The document details how to construct these damaged-style walls using laser-cut wooden pieces. It includes step-by-step instructions for each wall model, including how to attach the base, side walls, contour sections, and outer details. I am ready to help with any specific questions you might have about the assembly process or the components.
  • What type of glue is required?
    What tools are needed for assembly?
    What can be used to hold pieces together while the glue dries?
28mm Sci-Fi Walls – Damaged Wall Pack
B28-SFW-005 / 006 / 007
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and
remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place
while you allow glue to dry.
B28-SFW-005 – Damaged Wall #1 (65mm)
Each end of the wall is formed from the pieces
shown above.
Glue the two hooked pieces through the back plate,
ensuring the hooks all point in the same direction.
Add the outer layer.
Glue the end to the base.
The base is the longer of the two pieces.
Add the side walls.
Take the contour sections and glue 3 or 4 together
ensuring the notches align.
Glue the brace pieces into the notches. Then
continue to add the contour pieces.
Glue the contour piece into place as shown above.
Add the “lid”.
Attach the outer wall decoration.
If you want a flat end rather than a hooked one,
use the two pieces shown above in place of the
hooked end section.
The completed wall.
B28-SFW-006 – Damaged Wall #2 (45mm)
Each end of the wall is formed from the pieces
shown above.
Glue the two hooked pieces through the back plate,
ensuring the hooks all point in the same direction.
Add the outer layer.
Glue the end to the base.
The base is the longer of the two pieces.
Add the side walls.
Take the contour sections and glue 3 or 4 together
ensuring the notches align.
Glue the brace pieces into the notches. Then
continue to add the contour pieces.
Glue the contour piece into place as shown above.
Add the “lid” and outer wall decoration.
If you want a flat end rather than a hooked one, use
the two pieces shown above in place of the hooked
end section.
The completed wall.
B28-SFW-007 – Damaged Wall #3 (15mm)
The end of the wall is formed from the pieces
shown above.
Glue the two hooked pieces through the back plate,
ensuring the hooks all point in the same direction,
then add the outer layer.
Glue the end to the base.
Add the side walls.
Then glue the “lid” into position.
Take the contour sections and glue these into
position.
The completed wall section.
/