Magnadyne RV-Link WiFi System Installation guide

Magnadyne
Brand
Magnadyne
Model
RV-Link WiFi System
Category
Wall & ceiling mounts accessories
Type
Installation guide

This manual is also suitable for

WiFi System
WiFi Antenna Base/Housing
RV2400
Extender
RV2458
Router
For Technical Assistance, please call (800) 638-3600,
or visit www.magnadyne.com
Installation Manual
Cover Plate
Power
Cable
Wire Tie
Ethernet
Cable
2
Remove cover plate from wall. A) Bring Blue Ethernet and Blue Power Cables
through the wall.
B) Cut wire-tie & discard cover plate.
A) Bring Blue Ethernet and Blue Power Cables
through center hole of new cover plate.
B) Screw new cover plate to wall using
original mounting holes.
Mount Router Control Unit to wall near
the new cover plate as pictured using
included screws.
1
2A
2B
43
RV2458
Control Unit
3
Connect Blue Ethernet and Blue Power Cables
to RV2458 Control Unit as pictured.
Router Control Unit Installation Complete.
Remove 4 Machine Screws
(#10-24 UNC Threaded) and 4 Lock Wash-
ers from WiFi Housing on roof.
Cut Wire-tie from Blue Ethernet Cable
connected to the tube.
Set WiFi Housing aside. DO NOT extend
Cables from roof further than necessary.
WARNING
Do not connect a
computer or electronic
device to Ethernet port.
Will Cause Damage
Bottom View
Roof Repeater Only
5 6
7 8
Wire-tie
#10-24 UNC
Threaded
Machine
Screws
Lock
Washers
WiFi
Housing
4
Copyright © 2017 Magnadyne Corp.
RV-LINK-INS Rev. A
Place RV2400 Roof Repeater into Base in
location shown and screw to posts using
included screws.
WARNING
Use screwdriver and Hand Tighten only.
A) Plug Blue Ethernet Cable into RV2400 Roof
Repeater unit.
B) Wire-tie Blue Ethernet Cable to RV2400
Roof Repeater as shown. Add new wire-tie
to tube to provide strain relief.
RV2400 Roof Repeater Installation Complete.
The RV WiFi System is ready for use. Refer to
RV2458 Software Quickstart Guide for setup.
A) Place WiFi Housing back onto Base, make
sure Cables fit securely inside Base, are
not pinched, and do not interfere with
RV2400 antennas.
B) Attach 4 Machine Screws
(#10-24 UNC Threaded) and 4
Lock Washers to mount.
WARNING - Make sure the O-ring is in
place & screws are tight.
Machine
Screws
Lock
Washers
9 10
1211
RV2400
Roof
Repeater
TV Antenna
Cable
Radio
Antenna
Cable
Base
#10-24 UNC
Threaded
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Magnadyne RV-Link WiFi System Installation guide

Magnadyne
Brand
Magnadyne
Model
RV-Link WiFi System
Category
Wall & ceiling mounts accessories
Type
Installation guide
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents