RV-Link WF-CON-LTE Internet Extender for Recreational Vehicles Installation guide

Brand: RV-Link

Model: WF-CON-LTE Internet Extender for Recreational Vehicles

Type: Installation guide

This manual is also suitable for

WF-CON-LTE

WF-CON-LTE

Installation Manual

RV2402

Extender

RV2458

Router

For Technical Assistance, please call (310) 735-2000,

or visit www.magnadyne.com

Patent No.: US 10,622,709 B2

Patent No.: US D855,591 S

Type A

Type B

WF-CON-LTE

Installs Into These Pre Wired Antenna Models

Cover Plate

Screws (2)

RV2402 Extender

Screws (2)

Cable Tie

RV2458 Router

Control Unit

Screws (2)

Whats in the Kit

Recommended Tools

1) #2 Phillips Screwdriver

2) Small Open Ended Adjustable Wrench

3) Rubbing Alcohol

RV2458 Router

RV2402 Extender

LTE Paddle Antennas (2)

with Self Adhesive Tape

Be Sure to Read the Entire Manual Before Installation

Cover Plate

Power

Cable

Wire Tie

Ethernet

Cable

RV2458 Router Installation

Remove cover plate from wall.

A) Bring Blue Ethernet and Blue Power Cables

through the wall.

B) Carefully cut wire-tie & discard cover plate.

A) Bring Blue Ethernet and Blue Power Cables

through center hole of new cover plate.

B) Screw new cover plate to wall using

original mounting holes.

1 2

310 735-2000

RV-Link.com

Connect Blue Ethernet and Blue Power Cables

to RV2458 Control Unit as pictured.

Router Control Unit & Interior

Installation Complete.

WARNING

Do not connect a

computer or electronic

device to Ethernet port.

Will Cause Damage

Bottom View

Roof Repeater Only

Mount Router Control Unit to wall near

the new cover plate as pictured using

included screws.

RV2458

Control Unit

Remove 4 Machine Screws (#10-24 UNC

Threaded) and 4 Lock Washers from housing

on roof. Retain screws for reassembly.

Lift the housing off of base and disconnect

radio and TV cables.

CAREFUL - Do not let cables fall back

through antenna base into vehicle roof.

RV2402 Installation

Type A Antenna Type B Antenna

#10-24 UNC

Threaded

Machine

Screws

Lock

Washers

WiFi / LTE

Housing

TV Cable

Radio Cable

Paddle Antenna Connectors

Wi-Fi / LTE

Optional

GPS Port

Housing

Remove Machine Screw (#8-32 UNC Threaded

Pan Head Screw). Retain screw for reassembly.

Twist housing counter clockwise to unlock

from mounting base.

#8-32 UNC Threaded

Pan Head Screw

Attach paddle antenna connectors onto the

2 outside port connectors of the RV2402 Extender

(each marked by a red dot) and secure using

a small open ended adjustable wrench.

CAREFUL - Do not over tighten.

Reconnect TV / Radio cables. For Type A

Antenna, Cut Wire tie from Blue Ethernet

Cable connected to the tube.

MAC #

SER#

RV2402 Installation (continued)

Type A Antenna Type B Antenna

Wire Tie

Radio Cables

MAC #

SERIAL #

Paddle Antenna Paddle Antenna

Paddle Antenna

LTE Antenna

Position

LTE Antenna

Position

RV-Link Logo

Location

(topside)

Locking Screw Hole

TV Cables

Write down the mac address # and serial #

from the label on the back of the RV2402

in the space provided below.

A) To create a clean surface for the paddle

antennas, wipe down the inside of the

Wi-Fi / LTE housing with rubbing alcohol.

B) Peel off adhesive back from paddle antennas.

C) Firmly place into interior housing as shown.

IMPORTANT: Paddles should be positioned

opposite from each other for best reception.

A) To create a clean surface for the paddle

antennas, wipe down the inside of the

Wi-Fi / LTE housing with rubbing alcohol.

B) Peel off adhesive back from paddle antennas.

C) Firmly place into interior housing as shown.

IMPORTANT: 1 antenna should line up with

the housing units Locking Screw Hole.

4A 4B

Input: 12V/0.6A

FCC ID: ZGM-RV2402

IC: 23051-RV2402

RV2402

2.4G/5G WiFi & LTE

Multi-Band Extender/Repeater

Made in China

2010000000000000001

MAC:

S/N:

Patent No.:

US D855,591 S

Patent No.:

US 10,622,709 B2

Place RV2402 Roof Repeater into base in

location shown and screw to posts using

included screws.

WARNING Hand tighten with screw driver only

A) Plug Blue Ethernet Cable into RV2402

B) Wire tie Blue Ethernet Cable to center

tube of base. (Type A Antenna)

Roof Repeater unit.

A) Place housing back onto base. Make sure

cables fit securely inside base, are not

pinched, and do not interfere with

RV2402 antennas.

A) Aligning the Housing Locking Screw Hole and

Base Alignment Notch, place housing back

onto base. Make sure cables fit securely

inside base, are not pinched, and do not

interfere with RV2402 antennas.

B) Twist housing clockwise to lock into place and

secure together with the #8-32 UNC Threaded

Pan Head Screw that was removed in Step 1B.

C) Installation complete.

WARNING - Make sure the 0-Ring is in place

and pan head screw is tight.

B) To reassemble, use the 4 Machine Screws

(#10-24 UNC Threaded) and 4 Lock

Washers that were removed in Step 1A.

C) Installation complete.

WARNING - Make sure the O-ring is in

place and screws are tight.

Lock

Locking Screw

Hole

Alignment

Notch

Washers

9B9A

RV2402

Roof

Repeater

Blue Ethernet

Cable

Wire Tie

Base

#10-24 UNC

Threaded Machine

Screws

#8-32 UNC

Threaded Pan Head Screw

RV2402 Installation (continued)

Type A Antenna

Type B Antenna

ONE (1) YEAR LIMITED WARRANTY

Magnadyne Corporation or its authorized agents will within one year from the date of sale to

you, repair, replace or refund the retail sales price of said product or any part thereof, at the

option of the Magnadyne Corporation or its authorized agents, if said product or part is found

defective in materials or workmanship, when properly connected and operating on the correct

power requirements designated for the specific product. This warranty and Magnadyne

Corporation or its authorized agent’s obligations hereunder do not apply where the product

was; damaged while in the possession of the consumer, subjected to unreasonable or

unintended use, not reasonably maintained, utilized in commercial or industrial operations, or

serviced by anyone other than Magnadyne Corporation or its authorized agents, or where the

warning seal on the product is broken or the power and/or plugs are detached from the unit.

Magnadyne Corporation or any of its authorized agents will not assume any labor costs for the

removal and reinstallation of any product found to be defective, or the cost of transportation

to Magnadyne Corporation or its authorized agents. Such cost are the sole responsibility of the

purchaser.

This warranty does not cover the cabinet appearance items or accessories used in connection

with this product, or any damage to recording or recording tape, or any damage to the

products resulting from improper installation, alteration, accident, misuse, abuse or acts of

nature.

MAGNADYNE CORPORATION OR ITS AUTHORIZED AGENTS SHALL NOT BE LIABLE TO

ANYONE FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES OR CLAIMS EXCEPT THOSE

ACCORDED BY LAW. NO EXPRESSED WARRANTY OR IMPLIED WARRANTY IS GIVEN

EXCEPT THOSE SET FORTH HEREIN. NO IMPLIED WARRANTY SHALL EXTEND BEYOND ONE

YEAR FROM THE DATE OF SALE.

This warranty extends only to the original purchaser of the product and is not

transferable. Some states do not allow limitations on how long an implied warranty lasts, and

some states do not allow the exclusion or limitation of incidental or consequential damages,

so the above limitations or exclusion may not apply to you. This warranty gives you specific

legal rights, and you may have other rights that vary from state to state.

“NOTE: The manufacturer is not responsible for any radio or TV interference caused by

unauthorized modifications to this equipment. Such modifications could void the User’s

authority to operate the equipment.”

Defective merchandise should be returned to the original point of purchase or

secondly, to Magnadyne Corporation, 1111 W. Victoria Street, Compton CA 90220.

Return Authorization must be obtained before sending, or merchandise may be refused.

WF-CON-LTE_IM_Rev. B_04-14-20

Patent No.: US 10,622,709 B2

Patent No.: US D855,591 S

RV-Link WF-CON-LTE Internet Extender for Recreational Vehicles Installation guide

Brand: RV-Link

Model: WF-CON-LTE Internet Extender for Recreational Vehicles

Type: Installation guide

This manual is also suitable for

WF-CON-LTE

Download PDF

report

RV-Link WF-CON-LTE Internet Extender for Recreational Vehicles Installation guide

This manual is also suitable for

RV-Link WF-CON-LTE Internet Extender for Recreational Vehicles Installation guide

Related papers

Other documents