ROOMS TO GO 21300532, 21300493, 21300506, 21300518, 21300520 Assembly Instructions

Hello! I've reviewed the assembly instructions for the ALLISON BUNGIE Flat Low Back Office Chair. This document provides a detailed guide for assembling the chair, highlighting the initial pre-assembly of screws and washers. It also includes a function description for adjusting the chair height. Feel free to ask any questions about the assembly process or the chair's features.
Where are the screws and washers located?

What should I do with the preassembled screws and washers?

How to adjust chair height?

Assembly Instructions

ALLISON BUNGIE Flat Low Back Office Chair

PLEASE NOTE: Check that you have received all

components and hardware before assembling.

If you are missing any parts, contact your retailer.

During assembly, hand tighten screws only. When

the screws are in place, tighten completely.

IMPORTANT NOTE:

Screws and washers

(Parts G) are

preassembled into the

underside of the seat

(Part B). Remove screws

and washers from seat

and then use to attach

Part C to Part B, as

shown in step 1.

5mm

M8 x 14mm

4mm

1/4” x 5/8”

A (1 pc)

D (1 pc)C (1 pc)

G (4 pcs)

B (1 pc)

E (1 pc)

H (2 pcs)

F (1 pc)

I (1 pc) J (1 pc)

FRONT

* see

important

note

3.29.22 so

* Pull up to adjust

chair height

Function Description