Part List
IMPORTANT NOTE
Carefully remove all the parts from the carton and put
them individually on a soft cloth to prevent scratches
or other damages occuring to the parts.
We have taken great care in the design of this
product and request that you carefully and strictly
follow our assembly instructions to ensure a
completed product as it was designed.
Hardware List
Tools required for assembly : Phillips screwdriver
Home Styles Consumer Assistance Line 888-680-7460 and 877-831-0319
Swivel Chair
88 5 8601 1
M6x50
Head Cap Bolt
(50mm)
4pcs.(+1 extra)
Spring Washer
9 pcs.(+1 extra)
Flat Washer
13 pcs.(+1 extra)
Hex Wrench
1 pc.
85M6x
Head Cap Bolt
(85mm)
4 pcs.(+1 extra)
45Mx4
Wood Screw
8 pcs.(+1 extra)
20M6x
Head Cap Bolt
(20mm)
4 pcs.(+1 extra)
Small
Hex Wrench
1 pc.
A.
Seat
1 pc.
D.
Back Frame
.1 pc
H.
Side Stretcher
2 pcs.
B.
Arm
1 pc.
E.
Leg
2 pcs.
F.
Leg
2 pcs.
C.
Arm
1 pc.
I.
Base
1 pc.
G.
Side Stretcher
2 pcs.
M6x40
Head Cap Bolt
(40mm)
7 pcs.(+1 extra)
Assembly Instructions 2/4
IMPORTANT
* Do not tighten up all the screws until each part is properly assembled.
* You should keep Hex Wrench in a safe place as you may need to tighten up the Head Cap Bolts in the future.
STEP 1
Attach Stretchers (G) to Legs (E) and (F).
E
E
F
I
G
G
Figure 1
Head Cap Bolt (50mm)
STEP 2
Attach one leg unit to Base (I)
with Head Cap Bolts (50mm).
(see Figure 1)
Attach Stretchers (H) to base unit.
Attach the other leg unit to base
unit with Head Cap Bolts (50mm).
H
F
H
Assembly Instructions 3/4
STEP 4
Turn Seat (A) upside down.
Attach Back Frame (D) to Seat (A)
with Flat Washers, Spring Washers,
Head Cap Bolts (85mm) and Head
Cap Bolt (40mm). (see Figure 3)
Attach Arms (B) and (C) to unit with
Flat Washers, Spring Washers and
Head Cap Bolts (40mm). (see Figure 4)
STEP 3
Turn the base unit upside down.
Insert Wood Screws and tighten.
(see Figure 2)
Head Cap Bolt (85mm)
Flat Washer
Spring Washer
Figure 3
Figure 2
Figure 4
A
D
B
Wood Screw
Head Cap Bolt (40mm)
Head Cap Bolt (40mm)
Flat Washer
Spring Washer
C
Flat Washer
Spring Washer
Assembly Instructions 4/4
STEP 6
Place the base unit onto the top unit and
attach it with Flat Washers and Head Cap
Bolts (20mm). (see Figure 6)
STEP 5
Rotate the swivel plate. (see Figure 5)
Figure 6
Figure 5
Flat Washer
Head Cap Bolt (20mm)
/
