2. ROOMS TO GO
  3. 21300405

ROOMS TO GO 21300405 Assembly Instructions

  • Hello! I've reviewed the assembly instructions for the BABA Flat High Back Office Chair. This document provides a step-by-step guide to assembling your new chair, including details on components, hardware, and functions such as height adjustment, tilt, and lock. I'm ready to assist with any questions you may have about its assembly or features.
  • What should I do if I'm missing parts?
    Are screws preassembled?
    Should screws be fully tightened during assembly?
3.29.22 so
During assembly, hand tighten screws only. When
the screws are in place, tighten completely.
1 of 2
Assembly Instructions
BABA Flat High Back Ofce Chair
PLEASE NOTE: Check that you have received all
components and hardware before assembling.
If you are missing any parts, contact your retailer.
IMPORTANT NOTE #2:
Screws and washers (Parts
G) are preassembled into
the underside of the seat
(Part B). Remove screws and
washers from seat and then
use to attach Part C to Part
B, as shown in step 2.
IMPORTANT NOTE #1:
Screws and washers (Parts I)
are preassembled into the
underside of the seat (Part
B). Remove screws and
washers from seat and then
use to attach Part D to Part
B, as shown in step 1.
I (4 pcs)
M8 x 16mm
G (4 pcs)
M8 x 14mm
5mm
H (2 pcs)
1/4” x 5/8”
4mm
A (1 pc)
D (2 pcs)
J (1 pc)
B (1 pc)
E (1 pc)
K (1 pc)
C (1 pc)
F (1 pc)
I
D
B
J
J
G
C
1
3
2
4
6
E
A
FH
K
5
* see
important
note #1
* see
important
note #2
During assembly, hand tighten screws only. When
the screws are in place, tighten completely.
PLEASE NOTE: Check that you have received all
components and hardware before assembling.
If you are missing any parts, contact your retailer.
Function Description
2 of 2
3.29.22 so
3. To loosen or tighten chair tilt
1. To adjust chair height
2. Chair tilt and lock
* pull out * push in
*
* rotate
loosentighten *
* pull up
* press to adjust
armrest height
/