2. ROOMS TO GO
  3. 21300380

ROOMS TO GO 21300380, 21300392 Assembly Instructions

  • Hello! I've reviewed the Assembly Instructions for the BUNGIE High Back Office Chair. This document provides detailed, step-by-step guidance on putting together your new chair, including how to adjust its tilt, lock and seat height. I'm ready to help if you have any questions about the assembly process or the chair's features.
  • Where are the screws and washers located?
    What should I do if I'm missing parts?
    How to Adjust chair height?
3.29.22 so
During assembly, hand tighten screws only. When
the screws are in place, tighten completely.
1 of 2
Assembly Instructions
BUNGIE High Back Office Chair
PLEASE NOTE: Check that you have received all
components and hardware before assembling.
If you are missing any parts, contact your retailer.
IMPORTANT NOTE:
Screws and washers
(Parts H) are
preassembled into the
underside of the seat
(Part B). Remove screws
and washers from seat
and then use to attach
Part C to Part B, as
shown in step 1.
H
J (4 pcs)
M8 x 40mm 5mm 4mm
1/4” x 5/8”
M8 x 14mm
A (1 pc)
D (1 pc)
H (4 pcs)
L (1 pc) M (1 pc)
B (1 pc)
E (1 pc)
I (2 pcs)
C (1 pc)
F (1 pc)
G (2 pcs)
K (4 pcs)
LD
E
I
GJ
L
B
K
A
M
F
B
CH
6
3
7
4
1
8
5
2
FRONT
* see
important
note
During assembly, hand tighten screws only. When
the screws are in place, tighten completely.
PLEASE NOTE: Check that you have received all
components and hardware before assembling.
If you are missing any parts, contact your retailer.
Function Description
2 of 2
3.29.22 so
3. To loosen or tighten chair tilt
1. To adjust chair height
2. Chair tilt and lock
* pull out * push in
* pull up
*
* rotate
loosentighten *
/