2. SATELLITE
  3. Agwash Towel Dispenser Button

SATELLITE Agwash Towel Dispenser Button Operating instructions

  • Hello! I have reviewed the provided instructions for the Satellite Towel Dispenser Spring Button 22646. This document includes the steps for installing the spring button to enable secure locking of the towel dispenser. The instructions outline the required tools and parts, and describe how to install the button and rivet assembly. Feel free to ask me anything about the installation process or the functionality of the spring button.
  • What tools are needed for installation?
    What is the purpose of the spring button?
    How do you unlock the latch after installation?
AGWASH TOWEL DISPENSER SPRING BUTTON INSTRUCTIONS
Installation of Spring Button will hold the wire latch of the towel dispenser in the “LOCKED” or “UNLOCKED”
position. (TO UNLOCK THE LATCH PUSH THE SPRING BUTTON IN & SLIDE THE LATCH TO THE RIGHT).
PARTS KIT ( 22646 )
1. WASHER ( 11315 )
2. SPRING ARM BUTTON ( 22287 )
3. RIVET ( 11027 )
9/5/2018 REVA 22646 INSTRUCTIONS 1
2530 Xenium Lane North, Minneapolis, MN 55441
Telephone: 763-553-1900 Fax: 763-553-1905
800-328-3332 / www.satelliteindustries.com
TOOLS
- CORDLESS DRILL
- RIVET GUN
- 3/16 DRILL BIT
- 3/8 DRILL BIT
1
2
3
1. Open towel dispenser and move wire loop fully to left.
2. With wire loop fully to left, position hole end of Spring Arm
Button next to wire loop ( as shown below ).
3. Using 3/16 drill, transfer drill through hole ( see below).
Transfer drill
Bore hole out
TO 3/8”
4. Using 3/8 drill bit bore out 3/16 hole ( see below).
5. Place button into bored hole, press Spring down
firmly, and transfer drill using a 3/16 drill bit.
Transfer drill
3/16” HOLE
6. Place Spring Arm Button inside towel dispenser with Button
through 3/8 hole and hole aligned with 3/16 drilled hole.
5. Insert Rivet through 3/16 hole and hole in Spring Arm, then
place washer inside towel dispenser on rivet. Rivet assembly
into place with rivet-gun. Finished assembly with latch LOCKED.
/