Magtek ExpressCard 1000 Quick Installation Guide

  • Hello! I am an AI chatbot trained to assist you with the Magtek ExpressCard 1000 Quick Installation Guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Install Print Ribbon
Open the printhead by gently pulling
up on the (blue) release tabs.
Insert the printer ribbon by placing
the ribbon spools on the printer hubs.
Note: Match the green hubs to the
spool with the green ring.
Close the printhead by pressing it
CONTENTS
Two (2) Keys
Two (2) Card Weights
50 Blank White Cards
One (1) Printed Sample Card
One (1) Six-Foot Crossover Cable
One (1) AC Power Cable
One (1) Stylus (for monitor)
Thirteen (13) Encoder Cleaning Cards
Thirteen (13) Printer Cleaning Cards
IMPORTANT:
PRIOR TO INSTALLATION, PLEASE CONTACT THE MAGTEK HELP DESK
FOR THE LATEST INFORMATION ON THE EXPRESSCARD 1000.
Remove the beaded shipping
restraint before assembly.
STEP ONE
SETUP
Install Cleaner Roller Assembly
STEP TWO
Remove the cleaning roller assembly
by grasping the blue handle and
pulling the assembly upward.
Remove the cleaning roller hub by
gently pulling the hub supports apart
and removing the roller hub.
Insert the new cleaning roller hub.
by pulling on the indicated arrow.
Reinstall the cleaning roller by placing
the assembly back into the printer.
Load Blank Cards + Connect
STEP THREE
Load blank cards into the card hopper
right. Place the card weights on top of
the stack as shown above.
Connect the provided Ethernet cable.
Connect the power cable and turn on
the ExpressCard 1000 by pressing the
Print
STEP FOUR
press the [Menu]
Select [Samples].
Select the a card sample image and
press print. If you are unable print a
sample card contact Technical Support.
P/N 99875400 rev. 2.02 1/09
/