Way Basics WB-LITTER-2-BK Installation guide

Brand
Way Basics
Model
WB-LITTER-2-BK
Type
Installation guide

This manual is also suitable for

Help and Comments www.waybasics.com/contact
version 0418
CAUTION placing unit on its side or back
will compromise structural integrity. Use
right side up.
Important
THIS SIDE UP
1
2
Carefully remove the protective layer
leaving the 3M adhesive on Back
zBoard (adhesive shown in yellow)
and insert alignment pins.
Carefully remove the protective layer
leaving the 3M adhesive on Side zBoards
(adhesive shown in yellow) and insert
alignment pins.
Align Back zBoard to Bottom zBoard
and press down firmly.
3
4
5 6
18 Pins
Litter Mat
Bottom zBoard Top zBoard
magnet stopper
Back zBoard
Adhesive tape on 3 sides
2 Side zBoards
Adhesive tape on 2 sides
2 Doors
WARNING: CHOKING HAZARD
Small parts NOT for children under 3 years
• When moving your Way Basics unit, lift from the bottom
• Indoor use only. Not in bathroom.
Included
• Assemble your unit on a flat even surface
• Make sure zBoard surfaces are clean and dry
press
LITTER BOX
Orient door bottom pin as shown. Press on
spring loaded top pin and insert.
Align Litter Mat with pins on top.
Enjoy building possibilities!
Align Side zBoards to unit as shown.
Assure the edge with half adhesive
is facing up as shown.
Align Top zBoard to unit as shown
and press down firmly.
  • Page 1 1

Way Basics WB-LITTER-2-BK Installation guide

Brand
Way Basics
Model
WB-LITTER-2-BK
Type
Installation guide
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents