Way Basics PET-LITTER-GY Installation guide

Brand
Way Basics
Model
PET-LITTER-GY
Type
Installation guide

This manual is also suitable for

CAUTION placing unit on its side or back
will compromise structural integrity. Use
right side up.
2
3
1
4
5 6
7 8 9
Important
THIS SIDE UP
WARNING: CHOKING HAZARD
Small parts NOT for children under 3 years
18 Pins 1 Scratcher
2 Side
zBoards
1 Middle
zBoard
1 Back zBoard
Back zBoard
1 Top zBoard
2 Doors
1 Bottom zBoard
Included
CAT LITTER
Help and Comments www.waybasics.com/contact
version 042017
• Assemble your unit on a flat even surface
• Make sure zBoard surfaces are clean and dry
• When moving your Way Basics unit, lift from the bottom
• Indoor use only. Not in bathroom.
(Press)
(Press)
Carefully remove the protective
layer leaving the 3M adhesive on
zBoard (adhesive shown in yellow).
Insert alignment pins to back zBoard.
Align back zBoard to horizontal
zBoard. Press down firmly.
Insert alignment pins to side zBoards
and middle zBoard.
Align vertical zBoards to horizontal
zBoard as shown. Press down firmly.
Remove adhesive from side zBoards
and middle zBoard.
Align horizontal zBoard to unit as
shown. Press down firmly.
Orient door properly as shown and
align bottom pin. Press on spring
loaded top pin and insert.
Place cat scratcher in unit.
Put your cat litter box inside doors.
  • Page 1 1

Way Basics PET-LITTER-GY Installation guide

Brand
Way Basics
Model
PET-LITTER-GY
Type
Installation guide
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents