2. BLOTZ
  3. B20-ME-200

BLOTZ B20-ME-200, B20_ME_200, B28-ME-200 Assembly Instructions

  • Hello! I've reviewed the instructions for the BLOTZ Ancient City Walls, models B20-ME-200 and B28-ME-200. This document provides detailed instructions on how to assemble the model, including steps for gluing connectors, attaching walls, adding walkways, and more. I'm ready to answer questions you may have about the assembly process.
  • What type of glue is required for assembly?
    What tools are needed for assembly?
    Are there different versions of this kit?
20mm/28mm Ancient City Walls – Long Wall
B20-ME-200 / B28-ME-200
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
The images here show the 20mm version of this kit, but the 28mm version is constructed in exactly the same way.
Remove the pieces shown above from the sprue.
Glue the connectors to the main supports – the
wider connectors being the ones closest together.
Take the base and rear wall.
Glue the supports to the rear wall, then attach the
whole assembly to the base (see pic).
Add the walkway section, gently slotting each lug
into the corresponding hole.
Add the front lower wall.
Add the crennalation piece
Then attach the long strip.
The finished model.
/